40
Setup and installation
●
The dust extraction hose must be electroconductive and grounded to prevent
electrostatic build up.
●
Only use flame-retardant extraction hoses.
●
Use extraction with reduced dust emission to clean dust from the machine.
Ø 140 mm
Fig. 22: Attach the dust extraction hose
Tool:
●
Hose clamp
1.
Connect the flexible extraction hose to the extraction connection with hose
clamps.
2.
Check the extraction performance.
7.5
Connect electrics
7.5.1
Connect electrics
Electrical connection requirements:
●
The machine must be earthed with electrical conductors.
●
Pay attention to voltage fluctuations in the mains supply.
‘Electrical connection’ on page 21
●
The power supply cable must be protected against damage (e.g. armoured
conduit).
●
The power supply cable must be laid in such a way so that is does not bend
or chafe and that there is no risk of tripping over it.
Summary of Contents for FS 700 K
Page 6: ...6 Table of contents...
Page 59: ...59 FS 700 K Use 4 Switch machine on...
Page 75: ......