58
Use
9.3.7
Sanding curves
Using this working technique sand curved workpieces with large radius.
1
Fig. 41: Sanding curves
1 Sanding curves on the support table
NOTICE
Moving machine components
Material damage
−
Remove workpieces and fences from the support table before
tilting.
WARNING
Running sanding belt
Through contact with the running sanding belt it could cause
serious cut or abrasion injuries.
−
Avoid contact with the running sanding belt.
−
Only use the machine in manual operation.
−
Only process workpieces in reverse operation.
−
Ensure that workpieces cannot be ejected (use a workpiece
fence).
Take note of general procedures for permitted working methods.
1.
Adjust the table height to the workpiece to be processed.
2.
Check that all clamping levers are tightened firmly.
3.
Place the workpiece on the support table.
Summary of Contents for FS 700 K
Page 6: ...6 Table of contents...
Page 59: ...59 FS 700 K Use 4 Switch machine on...
Page 75: ......