43
!
"
!
"
#
$
!
"
#
Panel Saw
K3 basic/K3 winner/K3 e-classic
Making adjustments and preparations
8.7.3 Modifying the guide
Fig. 8-12: Parallel cutting fence
1.
Loosen the thumb screw.
2.
Pull the guide backwards.
3.
Place the guide flat onto the table and once again,
thread through the appropriate groove.
4.
Tighten the thumb screws.
!
Thumb screw
"
Guide
8.7.4 Removal
Fig. 8-13: Parallel cutting fence K3 e-classic
Fig. 8-14: Parallel cutting fence K3 winner
K3 e-classic:
It may be necessary to remove the parallel cutting fence
when machining large panels.
1.
Loosen the clamping lever.
2.
If present: Loosen the fine adjustment clamping lever
by 5-6 turns.
3.
Remove the parallel cutting fence from the track from
the top.
!
Parallel cutting fence
#
Clamping lever
"
Clamping lever
$
Track
K3 winner:
It may be necessary to remove the parallel cutting fence
when machining large panels.
1.
Loosen the knurled handle.
2.
Remove the parallel cutting fence from the back of
the bar.
!
Knurled handle
"
Parallel cutting fence
#
Bar
