69
!
"
!
"
#
$
%
&
/
*
) BL
BM
BN
BO
Panel Saw
K3 basic/K3 winner/K3 e-classic
Maintenance
10.8 Renewing the sliding table scraper blade (ball cage)
Fig. 10-7: Scraper
1.
Switch the machine off and ensure that it cannot be
switched on again.
2.
Disassemble the sliding table.
3.
Remove wheel bolts and worn scrapers.
4.
Mount new scrapers and tighten with wheel bolts.
5.
Assemble the sliding table.
!
Bolts
"
Scraper
10.9 Dismantling the sliding table
Fig. 10-8: Base
On the base, on the side from which the sliding table
should be pushed from the base:
1.
Remove fillister head screws and the base cover.
2.
Remove socket head cap screws and washers.
3.
Remove flat head screws.
!
Base
"
Discs
#
Socket head cap screws
$
Fillister head screws
%
Base cover
&
Sunken screws
Fig. 10-9: Sliding table length
On the opposite side on the sliding table:
4.
Remove fillister head screws and the sliding table
cover.
5.
Remove flat head screws.
6.
Counter hold the hexagon nut and loosen the flat
head screw.
7.
Remove the hexagon nut, flat head screw and
bearing shaft.
/
Sliding table cover
BM
Flat-head screw
*
Sliding table length
BN
Sunken screws
)
Bearing shaft
BO
Fillister head screws
BL
Six sided nut
