V.
Notice
：
1.
The grinder can be customized with the voltage of 110V or 220V, with the frequency of
60/50 Hz. Please use an independent socket instead of a multi-plug socket to avoid
un-stabilized voltage, which will cause the motor out of order. .
2.
Turn on the machine before pouring roasted nuts into the hopper. If users pour into nuts
before the auger functions, it may cause the auger stuck with the nuts. Users should turn
off immediately the power and disassemble the parts for cleaning.
3.
The lack of oiliness contained in the nuts and unroasted nuts are the main causes of lower
butter fluidity, which can cause the motor stuck. If the motor is stuck, turn off
immediately the power and dismantle the parts following the suggested steps for cleaning.
4.
If the motor was over-heated, the Auto Turn-off Safety Device would be activated to turn
off the machine. After the grinder cools down, turn on the power and the grinder would
work normally.
5.
If the auger and the grinding discs were stuck with ingredients, the Over-Current Safety
black button located on the back of the grinder would pop out automatically. Please switch
off the power and pull out the plug. Dismantle the parts for cleaning. After cleaning, press
the Over-Current Safety Device black button located on the back of the grinder. Once the
power is on, the grinder would be working normally.
6.
Please shred nuts that are in big size (almond, walnut, cashew, etc.) or press the nuts in the
hopper with the given wooden rod while grinding.
7.
It is not suitable to grind ingredients that do not contain oiliness (like rice) or that are rich
in liquid (like watermelon) or contains lots of fiber (like old ginger).
8.
If the power cord was damaged, contact the supplier or the distributor for a dedicated
cord.
9.
In the case when the fineness of the paste gets thicker, the butter contains less oil or the
front cap gets hotter than before, check the condition of the grinding discs with the given
Grinding Disc Diagnostics document.
10.
During the operating of the grinder, do not touch the auger with fingers or hard tools, but
only with the given wooden rod.
11.
To avoid water seeping into the motor, do not splash water on the machine and do not pour
water or oil into the hopper.
12.
To avoid scratches on the machine during transportations, a transparent film is sticked on
the machine shell for shipments. Users should remove the transparent film before turning
on the machine for the first time. The exhausting holes on the machine shell should be
un-covered while the machine is in operation.
13.
Before turning on the machine, tighten the funnel securing knobs, because the loosen
funnel securing knobs would make an abnormal loud noise.
14.
Users should never dismantle the auger. The installation of the auger defines the
Summary of Contents for NBM-100
Page 1: ......
