IV. Cleaning Process
：
After switching off the power, remove the auto feeding
device: Unplug the electrical cord located on the
electricity control area. Loosen up the two securing
knobs. Remove the auto feeding device.
After removing the Hopper by loosen up the securing
knobs, loosen the front cap securing knob to take off the
front cap
.
Push up the helical rod lock and hold it while turning the
grinding disc anticlockwise with the given wrench. After
loosen up the grinding disc, put down the wrench and turn
out the grinding disc anticlockwise with two hands to
avoid dropping it.
Loosen the hopper support securing knobs.
Remove the hopper support.
Clean
the disassembled
parts with a toothbrush.
The usage of detergent is
not necessary.
Do not disassemble the
auger. Clean it with a
wet towel or bring a toothbrush and clean water to
brush it. Do not bring the machine under water to
avoid water penetrating the motor.
Assemble them in reverse order. If there is any friction sound when the grinding disc
is rotating, the hopper support may not be installed well.
Securing
knob
Securing knob
Helical rod lock
Summary of Contents for NBM-500
Page 1: ......
