Felisatti APF200/1010E, Operating Instructions Manual

-

Inspect the mounting screws:

 Regularly inspect all 

the mounting screws and ensure they are firmly tight-
ened. Should any screw be loose, tighten it immedi-
ately. Failure to do so could put you at serious risk. 

-

Motor maintenance:

 Always take the greatest care 

over this and make sure that the motor winding is not 
damaged and does not become wet with oil or water. 

-

 The vents should always be kept clean and free of 

obstacles. 

-

  Clean the machine thoroughly after each use. Blast the 

motor regularly with compressed air. 

-

  Check that the mains lead is in good condition. If it is not, 

take it to an Official Service Centre to have it replaced. 

-

Brush replacement:

 The brushes should be replaced 

after 150 - 200 hours use or when they are less than 
10 mm long. Have this done by an Official Service 
Centre. We recommend that at every second change 
of brushes, you take the machine to one of our Official 
Service Centres for general cleaning and oiling. 

-

 Use only 

Felisatti

 accessories and spares. Parts the 

changing of which is not covered in this instruction 
manual, should be replaced in a 

Felisatti

 Official Ser-

vice Centre (See Warranty/Official Service Centre ad-
dress leaflet). 

Do not dispose of electric tools in 
the household waste! 

In accordance with European Directive 2002/96/EC 
relating to old electrical and electronic appliances and 
its translation into national law, used electric tools must 
be collected separately and recycled in an ecologically 
desirable way. 

WARRANTY 

See general warranty conditions printed on the attached 
sheet. 

NOISE AND VIBRATION 

This tool has been designed and made to reduce noise 
to a minimum. However, in spite of this

, in certain 

circumstances the maximum noise level in the place 
of work could exceed 85 dBA. In this case, the op-
erator should wear ear protection. 

The machine's noise and vibration levels, measured in 
compliance with EN60745-1, usually reach: 

Acoustic pressure = 90 dB(A) 

Sound-power level = 103 dB(A) 

Use ear protection! 

Vibration acceleration = 2.9 m/s

2 

DECLARATION OF CONFORMITY 

We hereby declare, under our sole responsibility, 
that the 

FELISATTI

 brand products described in 

this manual APF200/1010E comply with the 
following standards or standard documents: 
EN60745-1:2008, EN60745-2-3, EN60745-2-4, 
EN55014-1:2006+A1, EN55014-2:1997+A1+A2, 
EN61000-3-2:2006+A1+A2 and EN61000-3-
3:2008 in accordance with EU Directives 
2006/42/EC, 2006/95/EC, 2004/108/EC and 
2002/95/EC. 
 

11

 Francisco 

Ruiz 

Dir. Fábrica 

 
We reserve the right to make technical changes   08/2011