The instructions contained in this manual must be strictly
followed, it should be carefully read and kept close at hand to
use when carrying out maintenance on the indicated parts.
If the machine and charger are used carefully and normal
maintenance is carried out, they will work well for a long
time.
The functions and use of the tool you have bought shall be
only those described in this manual. Any other use of the tool
is strictly forbidden.
DESCRIPTION (See figures)
A Keyless drill chuck (Fig. 1)
B Torque adjustment ring (Fig. 1)
C Speed selector (Fig. 1)
D Forward/reverse switch (Fig. 1)
E On/off/speed adjustment switch (Fig. 1)
F Battery (Fig. 1)
G Battery release button (Fig. 1)
H Screwdriver bit (Fig. 1)
I Battery charger (Fig. 2)
J Charging light (red) (Fig. 2)
K Handle (Fig. 1)
L Lamp (Fig. 1)
M Hole for additional handle (Fig.1)
OTHER PRECAUTIONS
- Always connect the charger to a mains supply pro-
tected by a thermal cut out switch, for your own safety, in
accordance with established safety regulations regarding
low-voltage electrical installations.
- When drilling in walls, ceilings or floors, take care to
TECHNICAL DATA
ILLUSTRATIONS
Two-speed battery-driven hammer drills
DCHF13/18R2
Voltage
V
18
Battery capacity Ni-Cd
Ah
2,0
No load speed
Speed 1
Speed 2
/min
0-350
0-1350
Torque Speed 1/2Nm
Nm
25/23
ø drill in steel
mm
13
ø drill in wood
mm
0
ø Max. screw
mm
8
Drill chuck capacity
mm
13
Keyless chuck
+
Hammer
+
No. of torque settings
21
Reversible / Electronic
+/+
Charging Time
h
1
Weight according EPTA-Procedure 01/2003
Kg
2,
Noise and vibration
dB(A)
85
avoid electric cables and gas or waterpipes.
USES OF THE MACHINE
• Tightening and loosening screws for metals, screws for
wood, screw that do not require a hole to be drilled previously,
etc.
• Drilling in various types of metal.
• Drilling in various types of wood and plastic.
• Hammer drilling in brick, tiles, and masonry.
Any use that differs from the aforementioned is unau-
thorised.
ADJUSTMENTS AND FUNCTIONS
1. Forward/reverse switch (Fig. 1)
To select the direction of rotation:
• clockwise: push the switch D towards «forward» symbol
on the motor housing.
• anti-clockwise: push the switch D towards «back»
symbol on the motor housing.
The anti-clockwise turn enables screws and nuts to be
loosened.
Warning! Only push the forward/reverse switch D when the
machine is switched off.
2. Electronic speed adjustment (Fig.1)
The speed can be adjusted continuously, not by stages,
according to the pressure exerted on the on/off switch E, from
the machine being switched off to the highest value for both
speeds, as shown in the table.
3. Mechanical speed adjustment (Fig. 1)
These machines are equipped with a two-speed mechanism.
The selector C enables the speed to be adjusted to suit each
use.
Summary of Contents for DCHF 13/18R2
Page 1: ...ДРЕЛЬ ШУРУПОВЕРТ АККУМУЛЯТОРНАЯ DCHF 13 18R2 CORDLESS DRILL ...
Page 2: ... ...
Page 31: ...31 ...
