Felisatti NTF250/1200ST, Operating Instructions Manual

DECLARATION OF CONFORMITY

We hereby declare, under our sole responsibility, 

that the FELISATTI brand products described in 

this manual comply with the following standards or 

standard documents: 

Standard EN 61029

, Machine 

Directive 

98/37/EC

 and amendments, with 

2006/95/

EC

 and 

93/68/EEC

, and in regard to electromagnetic 

compatibility, with Directive 

89/336/EEC, EN 55014.1, 

EN 55014.2, EN61000.3.2

 and 

EN 61000.3.3

 and 

EN 

50366

.

Jordi Carbonell                         Santiago Lόpez

We reserve the right to make technical changes.  

9 PROBLEMS-CAUSES-REMEDIES

PROBLEMS

CAUSES

REMEDIES

The motor fails to work

Defective motor, power supply 

cable or plug. Fuses blown

Have the machine checked by 

pecialised personnel.

Never try to repair the motor 

yourself because of the potential 

danger involved.

Check the fuses and replace them 

ifnecessary. 

The motor starts slowly or does 

not reachoperating speed.

Low power supply voltage.

Damaged motor windings.

Condenser burnt out

Have the voltage checked by the 

power supply provider.

Have the motor checked by 

specialised personnel.

Have the condenser changed by 

specialised personnel.

Chipped or irregular cuts

The blade is dull

Sharpen or change the blade.

Step cut or irregular cutting 

surfaces.

Inadequate blade

Worn-out or defective blade.

Replace the blade with a more 

appropriateblade.

Change the blade.

MITRE SAW:

Cuts not made at the desired 

angle.

Inadequate squaring.

Clean the stroke-ends.

Adjust the turntable and the 

stroke-ends.

UPPER TABLE:

Difficulty in cutting.

Blade – splitting wedge out of 

alignment.

Regulate the splitting wedge 

and  the  protective  casing  fixing 

bracket.

Crooked trimming.

The guide is not parallel to the 

blade.

Align guide and blade.

Protective casings or moving 

parts jammed.

Chips or dirt have not been 

removed.

Perform a thorough cleaning by 

spraying

compressed dry air.

The motor fails to start when the 

starting button is pushed.

Switch malfunction.

Cables disconnected or broken.

Condenser malfunction.

Contact authorised Assistance 

centers.

The blade stopping times lasts 

longer than 10 seconds.

Electronic module malfunction.

Contact authorised Assistance 

centers.