Model
NTF250/1200ST
NTF305/1600ST
Tension and current
V / A
230V-5,5A
230V-8A
Frequency
Hz
50
50
Absorbed power
W
1200
1600
Idling speed
/min
4500
4000
Cut at 90°/crop (AxB fig. 3)
mm
73x150
102x150
Cut at 45°/crop (AxB fig. 4)
mm
73x90
97x102
Cut at 45°/blade at 45° (AxB fig. 6)
mm
46x150
66x150
Cut at 45°/blade at 45° (AxB fig. 6)
mm
45x48
45x53
Cut on upper table
mm
40
66
Upper table dimensions
mm
473x312
473x312
Blade diameter
mm
250
305
Blade hole diameter
mm
30
30
Weight
kg
22
25
Overall dimensions (LxHxW)
mm
520x396x650
573x432x667
Sound pressure emitted
Lpa dB(A).(*)
91
96
Sound power emitted
Lwa dB(A).(*)
104
109
Vibration level
m/s2 (*)
1,0 (<2,5)
0,7 (<2,5)
* Reliefes enforced by the standard: EN 61029
2.2 STANDARD ACCESSORIES
This series of mitre saws is supplied complete with
the following set of standard accessories:
Adjusting rod (fig. 7): required for the cutting of beams
of the same length.
Pusher For the working of small parts on the upper
table (fig. 20).
Blister pack of Allen wrenches.
Important: the equipment provided may vary
according to the sales campaign in progress.
2.3 ACCESSORIES AVAILABLE ON REQUEST
The following accessories for particular work
conditions are also available on request:
Rapid clamp: (fig. 8) permits the tighter locking of
bars and sections without vibration.
Foldable and movable universal support for mitre
saws (A fig. 19).
Support and roller unit (B fig. 19) for jutting piece
Vacuum unit (C fig. 19) with connection tube and
spout.
Goniometer: to make angled cuts on the upper
table
(fig. 21).
Workpiece support stroke-end raised section (G
fig.1
WARNING!
The use of accessories or attachments
other than those recommended in this manual may
pose risk of injury.
2.4 SAFETY DEVICES
In rest position, the blade is completely protected
by two fixed casings and one movable casing with
opening that is automatically triggered by the lowering
of the blade unit during the execution of the cut.
On the upper table, the blade is protected by a casing
that is raised over the workpiece as it approaches the
cutting point.
WARNING!
Never remove these protective casings
that enable the operator to work in conditions of
safety.
WARNING!
CHECK ALL DAMAGED PARTS
• All the parts of the tool should be carefully checked
before use in order to make sure that they will work
correctly for the operation foreseen.
• Check the alignment and assembly of all moving
parts for signs of breakage and any other conditions
that might compromise operation.
• Damaged protective casings and/or other parts
should be replaced by an authorised service center
unless indicated otherwise in this manual.
• Have defective switches replaced by an authorised
service center.
If the LOCK in “ON” button has not been pressed,
the blade automatically stops when the starting
lever switch in the handgrip is released.
WARNING!
Pressing the LOCK in “ON” button disables the safety
feature provided by the Manufacturer in the starting
2.1 TECHNICAL DATA
Summary of Contents for NTF250/1200ST
