16
MOUNTING TEMPLATE GUIDES
WARNING! Disconnect tool from power source.
For template routing the Felisatti RF67/2200 accepts
standard template guides which are available
separately. To use template guides an optional
adapter ring must be attached to the base plate
using the two slotted screws provided. Remove the
slotted screws from the base plate, insert the
adapter ring with the flat side toward the router body.
Install and tighten the screws to secure the adapter
ring. - Fig. 17
The base plate has been centered at the
factory, however, if the base plate has been
removed and remounted some adjustment may
be necessary to center the template guides to
the router bit. To adjust, loosen the four base
plate screws that secure the base plate to the
router, reposition the base plate and tighten the
screws.
Fig. 17
OPERATING INSTRUCTIONS
WARNING! Make sure that the voltage from
the power supply matches the voltage specified
on the tool. Before plugging in the tool ensure
that the bit is properly inserted and tightened
and that it spins freely.
1. Powering the Tool On and Off
a) Plug in the tool with the Trigger Switch in the OFF
position and the lock button released.
b) Hold the router firmly by both handles with the bit
away from you and positioned so that the bit is
not in contact with the wood or any part of your
body or clothing.
c) Start the tool by depressing the Trigger Switch.
Fig 18
d) Lock the tool in the run position by depressing
the Locking Button with your thumb while the
Trigger Switch is on. Release the Locking Button
by momentarily depressing the Trigger Switch
and releasing.
e) Turn off the tool by releasing the Trigger Switch.
Fig. 18
