Felisatti RHF40/1100VERT, Operating Instructions Manual

7

3. Fit and adjust the side handle.

4. Pull the trigger switch and start working.

5. Push with only enough force to keep bit from bouncing. 

Pressing very hard on the tool will not increase chipping 

speed.

6. To stop the tool, release the trigger switch. Always turn 

the tool off when work is inished and before unplugging

10. Operation time

The tools shall be operated intermittently as fallows;

-  Operating time : 30 s

-  esting time : 90 s

  11.VCS (Multi Vibration Control System) 
(

RHF40/1100VERT

,

 RHF40/1100VERTM

)

The VCS function reduces occurring vibration.

NOISE AND VIBRATION

This  tool  has  been  designed  and  made  to  reduce 

noise to a minimum. However, in spite of this, 

in certain 

circumstances the maximum noise level in the place of 
work could exceed 85 dBA. In this case, the operator 
should wear ear protection.
 

Use ear protection!

WARNING!

  The  vibration  level  given  in  these 

instructions has been measured in accordance with 

a  standardized  measurement  procedure  speciied  in 

EN60745 and can be used to compare devices. Different 

uses of the device give rise to different vibration levels and 
in many cases they may exceed the values given in these 

instructions. It is easy to underestimate the vibration load 

if the electrical power tool is used regularly in particular 

circumstances.

Note.

 If you wish to make an accurate assessment of 

the vibration loads experienced during a particular period of 
working , you should also take into account the intervening 
periods of time when the device is switched off or is running 

but is not actually in use. This can result in a much lower 

vibration load over the whole of the period of working.

ACCESSORIES

Accessories and their corresponding order number 

can be found in our catalogues.

MAINTENANCE

1. Checking the Tool (bit)

Using the worn-off bit will cause overloading the motor 

and  reduce  work  eficiency.  Either  sharpen  the  tool  or 

replace with a new one.

2. Checking the Screws

Check  if  any  screw  is  losen.  Losen  screw  must  be 

fastened irmly.

Replacement  of  screw  must  be  carried  out  at  the 

authorized  A/S  center  using  genuine  parts.  Otherwise 

Commutator may worn out quickly shortening the service 

life of the Tools.

3. Maintenance of Motor Assembly

The Commutator in the Motor Assembly is the core 

part of the tool. Be careful not to cause scratch or contact 

with oil or water on the surface of the Commutator.

4. Storing after Use

Store the tool in a dry place out of reach of the 

children.

5. Repair

If the tool is not operating normally, do NOT attempt 

to locate the problem or repair yourself. Contact nearest 

authorized A/S center for service.

6. Cord

If the supply cord of this power tool is damaged, it 

must be replaced by a specially prepared cord available 

through the service organization.

WARRANTY

See general warranty conditions printed on the 

attached sheet.

DISPOSAL

WARNING! Do not dispose of electric tools in the 
household waste!

In  accordance  with  European  Directive  2002/96/EC 

relating to old electrical and electronic appliances and 
its translation into national law, used electric tools must 
be collected separately and recycled in an ecologically 

desirable way.