6
Wet stone grinder
WG130/1300VE
Voltage
V~
230
Frequency
Hz
50-60
Input power
W
1300
No-load speed
min
-1
400-2200
Max grinding tool diameter
mm
130
Tool holder
M14
Protection class
I
Weight according EPTA-Procedure 01/2003
kg
5.3
Water connection
1/2 ‘‘
TECHNICAL DATA
Read the operating instructions
Protection category II power tool; double
insulated
In accordance with essential applicable safety
standards of European directives
Wear eye protection
Wear ear protection
Follow very carefully the instructions in this manual,
save it and keep it close at hand, ready to carry out any
inspection of parts that may be necessary.
If the tool is used with care and normal maintenance is
carried out, it will work well for a long time.
The functions and use of the tool you have bought
shall be only those described in this manual.
Any other
use of the tool is strictly forbidden.
ILLUSTRATIONS
DESCRIPTION (See figures)
1 Fixed spanner
2 Auxiliary handle
3 Brush holder cap
4 Speed regulating handwheel
5 On-/off switch
6 Safety push button switch
7 Quick coupler
8 Spindle
9 Water supply hose
10 Grinding disc
11 Protective shroud
12 Switch PRCD
EQUIPMENT
- 1 auxiliary handle
- 1 27 mm fixed spanner
- 1 17 mm fixed spanner
- Operating instructions
- Safety instructions
- Warranty
BRIEF DESCRIPTION
This grinder has been designed to polish wet or dry
stone with emery paper with grinding cups or crowns. It
can also be used to polish and brush metallic or painted
surfaces without adding water.
BEFORE USING THIS TOOL
Before using the tool, make sure the mains voltage
is correct: it must be the same as that on the specification
label. Machines with 230V can also be connected to a 220-
V mains supply.
Before plugging in the tool, always make sure the
control switch A works properly and returns to the OFF
position when released.
Connection to the power supply - power tools with
PRCD switch
WARNING!
These machines may be operated with
the supplied PRCD switch only. Before using the machine,
always check the PRCD switch.
Always check the machine before use:
1. Insert the mains plug into the socket.
2. Press “RESET» button. The red indicator light must
come on.
3. Press “TEST» button. The PRCD switch must switch
off and the indicator light go out.
4. When the “RESET» button is pressed again, it must
be possible to switch on the machine.
WARNING!
If the PRCD switch repeatedly switches
off when the machine is switched on or if the PRCD switch
does not trip, immediately disconnect the machine from
the power supply. Do not continue using the machine.
Have the PRCD switch replaced by appropriately qualified
technicians or customer service only.
Connecting the water
WARNING!
Keep water away from the electric power
tool and from people within the operating range. Do not
switch on power tools which have not been connected
correctly to the water supply. Regularly check that seals,
shut-off valve and connectors function correctly.
- Attach 1/2» water hose 9 to standard self-locking
quick coupling 7.
- Do not open shut-off valve until at the place of use and
the grinding tool is rotating .
