P
age
15
support@FELIXprinters.com
www.FELIXprinters.com
User manual FELIX 3.0 3d printer
4.3
Calibrate the Z-Direction/Connect to printer
To obtain good quality prints it is
essential
that the heated bed is
level
and that the distance between the hot-
end and the bed is close enough when printing the first layer.
The leveling was done prior to the software installation. So now it is time to calibrate the z-axis height with the
z-axis limit switch vane.
1.
Connect to the printer. (The connect button should turn green)
Other checks to see if the printer is connected properly:
On the bottom of the Repetier-Host program the following should be displayed
If you see
… commands waiting
, press the reset button, which is on the side of the electronics case next
to the SD-card and USB sockets.
2.
Go to the
manual control
tab. (This looks different on the Mac, but has the same functionality)
3.
Now it is time to calibrate the z-height:
When doing the following steps, hold your hands on the power switch of the power supply. Flip the
switch if something goes wrong.
-
Press the Power button. This will turn on the power circuit of the electronics board.
If you have built a DIY kit: Do the following checks to ensure you have connected the wires correctly.
o
Make sure the fan which blows air on top of the hot-end is spinning
o
Make sure the LEDs of the opto-sensors on the electronics board are reacting by checking to
see that the appropriate lights go out when they are triggered. When a limit switch vane goes
between the sensor flanges, the correct light should turn off.
Home
X
, Y and Z
button
Home All axes
button
