MAN OVER BOARD SEQUENCE
MAN OVER BOARD
WIRELESS MOB DETECTION
AUTO ENGINE STOP
If this is the first time you use the MOB+, visit
www.fellmarine.com/explore
To see install videos, demos, FAQs, online user manual and other
support material, visit:
www.fellmarine.com/support
Thank you for choosing MOB+!
Disconnect battery cables at battery before attemting to install this
product
Read all instructions carefully before use of this product.
FELL Marine equipment and accessories are designed to the best industry
standards for use in the recreational marine environment. Their design and
manufacture conforms to the appropriate Electromagnetic Compatibility
(EMC) regulations, but correct installation is required to ensure that
performance is not compromised. Please see section EMC Installation
Guidelines in the User Manual for optimum EMC conditions.
Within the wireless range MOB+ will not shut down the engine automatical-
ly e.g. if you fall in your boat within the wireless range the engine will not
stop automatically. In this event, you can shut down the engine by pressing
the button on your MOB+ xFOB or on the MOB+ xHUB. Always check your
wireless range before use.
Installation
WARNING
The xFOB™ is waterproof down to 10 ft/3m and can be reused after
MOB event. After an MOB-event, the engine can easily be restarted by;
•
dStart™ - 6 seconds after a MOB Event the system lets
passenger restart the engine to pick up the missing person in
the water. The engine can be started without reconnecting the
xFOB. No interaction with xHUB necessary.
•
Reconnect with the xFOB by clicking once on the xFOB to
deactivate dStart™ and once more to connect.
IMPORTANT INFORMATION
11,5 mm
(0.45 inch)
44 mm
(1.7 inches)
28 mm
(1.1 inches)
Measurements and performance
Weight
10g / 0.35oz.
Housing material
ASA / TPU / POM
Temperature range
From -15°C / 5°F to 55°C / 131°F
Voltage Source
Coin Cell Battery - 3V nominal
Power consumption
0.3 µA in sleep (0.00033 W) 30 mA in active mode (0.098W)
Battery life
300 hours continous usage
Wireless performance
Frequency area
EU:
868 MHz
US:
915 MHz
RF signal (in)
10 dBm max.
RF signal (out)
10 dBm max.
4D Antenna diversity
Battery xFOB
Battery type
CR2032
Battery voltage
3V lithium battery
Certifications and compliance
Radio - xFOB
EU:
R&TTE, EN 300 328,
Maritime/CE
US:
FCC Part 15C
EMC - xFOB
EU:
EN 301 489-01
(V1.9.2), Class A
US:
CISPR 16-1
Flammability - xFOB
IEC 60950 1&22, CE-UL94
Immersion xFOB
IEC 60945, IP68, Maritime/CE - 3m / 10ft. water resistant
RoHS (2002/95/EC) compliant materials
ABYC A-33 compliant
Measurements and performance
Weight
164g / 5.8oz.
Housing material
ASA / TPU / PBT / POM – RoHS
Temperature range
From -15°C / 5°F to 55°C / 131°F
Voltage Source
10-32Vdc
Power consumption
Active Mode: 180mA (2.5W max. at 13.8Vdc), Standby: <30mA,
<0.4W max. at 13.8V
Fuse
1A-3A
Alarm decibel level
>85db
Kill Switch Relay Max Current Tolerance
5A continuously
Wireless performance
Frequency area
EU:
868 MHz
US:
915 MHz
RF signal (in)
10 dBm max.
RF signal (out)
10 dBm max.
4D Antenna diversity
Certifications and compliance
Radio - xHUB
EU:
R&TTE, EN 300 328,
Maritime/CE
US:
FCC Part 15C
EMC - xHUB
EU:
EN 301 489-01
(V1.9.2), Class A
US:
CISPR 16-1
Flammability - xFOB
IEC 60950 1&22, CE-UL94
Immersion xFOB
IEC 60945, IP68, Maritime/CE - 3m / 10ft. water resistant
RoHS (2002/95/EC) compliant materials
ABYC A-33 compliant
228 mm
(9 inches)
166 mm
(6.5 inches)
49 mm
1.9 inches)
66 mm
(2.6 inches)
62 mm
(2.45 inches)
52 mm
(2 inches)
17 mm
(0.7 inch)
•
I already have an existing kill switch. Can I install MOB+™?
-Yes. MOB+ is installed using wires from your existing kill switch. Please see
installation guide for instructions
•
I have a boat made from metal. Can I install MOB+?
-Actual signal reduction, if any, will vary from boat to boat. Should the signal
be noticeably worse, we recommend using an external antenna to put on the
top side of the helm, supplied from FELL Marine.
•
Can passengers start the boat if I were to fall over board?
-Yes, this is one of the main features of MOB+. 6 seconds after a MOB
Event the system lets passenger restart the engine to pick up the missing
person in the water.
Click the button on your xFOB to connect.
CONNECT
Click the button on your xFOB™ to disconnect.
DISCONNECT
In the event that you forget your xFOB™ or if it´s
out of battery - don´t worry. You can easily override
MOB+™ by holding the button on the xHUB™ for 10
seconds. The xHUB will give a sound and a yellow
light signal to indicate Override Mode is activated so
you can start boating.
OVERRIDE MODE
dStart
™
dStart™ is the direct restart feature in the MOB+™
system. 6 seconds after a MOB-Event the MOB+
lets any remaining passengers in the boat restart
the engine to pick you up in the water should a MOB
event occur. When you get back on board you can
reconnect by one click on the xFOB™.
The xHUB™ will give a sound signal and a red
light to indicate Disconnect.
The xHUB™ will give a sound signal and a green
light to indicate a successful connection.
It’s obvious, there’s no comparison with traditional corded lanyards. The
MOB+ is safer and easier to use. Just wear the xFOB™ as you want, and
click once when entering your boat for the next boating trip to connect.
That’s it!
MOB MODE
MOB Mode (
Man Overboard Mode
) is the safety mode of the system.
MOB+™ will automatically activate shut down of the engine when the
xFOB™ is submersed in 4 inches (10 cm) of water or travels out of range
from the xHUB™. After 6 seconds, the system automatically activates
Override Mode. In Override Mode any passenger or crew onboard can
restart he engine without the need to interact with the MOB+ system.
This allows for a quick recovery of the missing person in the water and
enhances safety.
FELL AS
Designs, manuals and features subject to change.
For more information visit our website:
www.fellmarine.com
Direct Restart
Drive
MOB
Makes it possible for
passengers to start
the engine 6 seconds
after a MOB incident
to quickly rescue the
person in the water
FREEDOM ONBOARD
Range up to 50 feet.
4D antenna diversity
ensures a robust
connection. Enjoy higher
seas and stronger
winds
Should you fall over
board the engine
will stop as you hit
the water
LEARN MORE AT: WWW.FELLMARINE.COM
TIME-OUT FUNCTIONS
FAQs
ONE CLICK USER INTERFACE
TECHNICAL SPECIFICATIONS - xFOB™
TECHNICAL SPECIFICATIONS -xHUB™
CAUTION
Connected: 20h Time-Out:
The normal xFOB to xHUB connection will
automatically time-out after 20h. This is to prevent unnecessary battery
drainage of the xFOB battery. Click xFOB again to reconnect.
Override Mode: 8h Time-Out:
Override Mode automatically times out
after 8h to prevent engine start if the boat is left unobserved.
MOB Mode: 2h Time-Out:
MOB Mode automatically times out after 2h.
This is to prevent engine start if the boat is left unobserved after leaving
the boat without disconnecting the xFOB.
MOBP17001
MOBP17002
MOBP17003
MOBP17004
MOBP17005
MOBP17006
MOBP17007
MOBP17008
MOBP17009
