20
NOTICE
FAILURE TO FOLLOW THESE INSTALLATION
INSTRUCTIONS COULD RESULT IN FIRE,
ELECTRIC SHOCK, OR OTHER INJURY OR
DAMAGE.
We recommend that the installation of the
WiMEA in your boat is performed by skilled
personnel familiar with electric wiring, or by a
professional mechanic or electrician. This is to
prevent any malfunction of the device related
to installation.
The Boat Unit should be mounted in the helm
or as near as possible to the driver position of
the boat.
You can choose to keep the original kill switch.
If so, connect WiMEA in series if you have Open
to stop principle or parallel to the existing kill
switch if you have a Close to stop principle.
Please note that you always have to use your
existing kill switch when using this setup.
NOTICE
NOTICE
It may be easier to connect the kill switch signal
wires to the Connection Cable before mounting the
Boat Unit completely in your helm, depending on
your helm/boat. Connect the wires as described in
section “Connecting the wires”. Then connect the
Boat Unit Cable and the Connection Cable by
connecting the male and female 5-pin IP67
Connectors before doing final mounting of the Boat
Unit. Connect the Boat Unit Cable to the Connection
Cable between bullet point 3 and 4 on page 19,
“Mounting the Boat Unit”.
TIP
Summary of Contents for WiMEA
Page 2: ...17...
