FELLER ENGINEERING SS 242, Manual

Steam rate control buttons 

The steam rate can be selected low, medium or high with the two steam rate 

control buttons (see the schematic illustration of Control panel). Any one to 

be selected, its indicator will flash, after a few minutes, the indicator will be 

changed to illuminating. At this time, the appliance can produce steam and 

then you can use the steam for ironing.

Temperature dial

Turn the dial to set ironing temperature to meet the garment changed.

Temperature indicator 

When the iron is heating up, the temperature indicator will be illuminated. 

Once the iron has reached the selected temperature, it will extinguish. The 

temperature indicator will be cycled on and off as the iron maintains the 

selected temperature during ironing. 

Steam release button

After pressing down the Power switch and choosing the desired steam rate, 

it indicates the steam can be used for ironing until the steam rate indicator is 

changed flashing to illuminating. At this time, press the steam release button 

with a little force, the steam will be sprayed from the soleplate continuously. 

When loosen the steam release button, the appliance can only be used for 

dry ironing without steam.

Surge of steam control button

After pressing down this button, you can get powerful steam instantly for 

better ironing and removing tough wrinkle.

Lack of water indicator

If less water in the tank, the indicator will be illuminated, following with two 

“D” sounds of buzzer, the steam generator stops working. It prompts you 

need to add water into the tank. If the pump keeps pumping water for more 

than 1 minute, the indicator will be flashed. At that time, just the iron can 

work.

5