FELLER ENGINEERING SS 242, Manual

USING YOUR STEAM STATION IRON

The appliance has two iron portions. You can use dry ironing or steam iron-

ing, the details refer to the following:

Dry ironing
1. 

Put the iron on the steam station iron’s thermal insulation cushion.

2. 

Connect the plug to wall outlet and press down the Power switch and 

the power indicator will be illuminated. 

3. 

Turn temperature dial to your desired setting, which is depended on the 

fabric of garment, and the temperature indicator will illuminate. Refer to 

IRONING TIPS latter. The iron starts heating.

4. 

When the temperature indicator turns off, the selected temperature is 

reached. You now can start ironing. 

WARNING: Never touch hot soleplate at any time before cooling down!  

Steam ironing
1. 

Grasp the water tank’s handle with one hand and press the trigger with 

one finger to take out of the water tank, then open the filling cap and 

fill water into it. You had better use purified water with less calcium par-

ticles. After it, close the filling cap. The max capacity of water tank is 1.7L, 

the water level shall not be exceeded the MAX mark. 

2. 

Replace the detachable water tank properly.

3. 

Put the iron on the steam station iron’s thermal insulation cushion.

4. 

Connect plug to the wall outlet, press down the Power switch and the 

power indicator will be illuminated, and the defaulted low steam rate 

indicator will flash. Turn temperature dial to your desired setting, which 

NOTE

: When you switch on the appliance, the steam generator may produce 

a pumping sound. This is normal; the sound tells you that water is pumped 
into the steam generator.

NOTE

: During the heating process of the soleplate, there will be little steam 

coming out from the soleplate automatically and this phenomenon will con-
tinue for about 3 seconds, This is normal.

7