FELLER ENGINEERING SS 242, Manual

AUTO CALC CLEAN FUNCTION

This appliance is equipped with an Auto Calc Clean function. Over time, 

scale particles build up inside the steam generator. If the descaling indica-

tor illuminating, it indicates the steam generator shall be cleaned by virtue 

of the mineral deposits collecting to a degree (after using 6 to 8 tanks of 

water). The appliance automatically performs a Calc Clean process to clean 

itself from scale.
Note: After the descaling indicator illuminating, the appliance may not enter 

to Auto Calc Clean process unless the appliance is sufficiently cold.

1. 

When the Auto Calc Clean process takes place, the descaling indicator 

flashes and you can hear short beeps. Wait approximately 2 minutes for 

is depended on the fabric of garment, and temperature indicator will 

illuminate. Refer to IRONING TIPS latter.

5. 

The water in the tank will be heated, after a few minutes, the tem-

perature indicator will be extinguished, which indicates the soleplate 

temperature has achieved the selected temperature. If the indicator of 

defaulted steam rate has been changed flashing to illuminating, it indi-

cates you can take out of the iron and iron the garment with steam by 

pressing the steam release button of the iron.

6. 

According to your requirement, you can select the desired steam out-

put for each garment, there are three modes of low, medium, high on 

available. Make sure that there is enough water in the tank.

Caution:  1) Do not touch hot soleplate at any time before cooling down!
 

2) Never direct the steam at people!

3) Don’t emit the steam directly to the people.

7. 

During operation, if there is less water in the tank, the lack of water in-

dicator will be illuminated, following with two beeps can be heard. At 

that time, you should refill the water tank through the filling aperture or 

move out of the water tank to refill it. 

8. 

After finish ironing, press and hold the Power button for a while, and the 

appliance will be turned off and all the indicators will be extinguished. 

Or you can put the iron the thermal insulation cushion, if there is no 

steam sprayed out from the soleplate within 10 minutes, the appliance 

will be turned off automatically. Remove the plug from the wall socket. 

But the soleplate is still hot, never touch it with hand, place it on the 

thermal insulation cushion until it cools down completely.

8