Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.
CLEANING AUTO-START INFRARED SENSORS
PRODUCT MAINTENANCE
Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors may become blocked by paper dust causing the motor to run
even if there is no paper present
(Note: two paper detection sensors are located in the center of the paper entry)
.
TO CLEAN THE SENSORS
Turn off and unplug
shredder
Locate Auto-start
infared sensor
Using cotton swab, wipe
away any contamination
from the paper sensors
Dip cotton swab in
rubbing alcohol
AUTO
AUTO
AUTO
1
ENGLISH
Models 225Ci/225i
All cross-cut shredders require oil for peak performance. If not oiled, a machine may experience diminished sheet capacity, intrusive
noise when shredding and could ultimately stop running. To avoid these problems, we recommend you oil your shredder each time you
empty your waste bin.
OILING SHREDDER
15
15
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
*Apply oil across entry
PREvENTIvE MAINTENANCE & ACCESSORIES
TROUBLESHOOTING
4
Press and hold forward
( ) 2-3 seconds
AUTO
AUTO
AUTO
2
A
B
C
D
A. Door Open Indicator:
The shredder will not run if the cabinet door is open. When illuminated, close the
door to resume shredding.
B. Bin Full Indicator:
When illuminated, the shredder waste bin is full and needs to be emptied. Use Fellowes
waste bag 36054.
C. Remove Paper Indicator:
When illuminated, press reverse (
) and remove paper.
Reduce paper quantity to an acceptable amount and refeed into paper entry.
D. SafeSense
®
Indicator:
If hands are too close to the paper entry, the SafeSense
®
indicator will illuminate
and the shredder will stop shredding. If SafeSense
®
is active for 3 seconds, the shredder will automatically
turn off and the user must press the power button on the control panel to resume shredding.
Self Cleaning
Cycle:
Shredder periodically cycles in forward and reverse lasting 3-6 seconds (225Ci only).
3
C-2
25
C -2 2 5
2
4
C-2
25
1
