3
SET-UP AND TESTING
Set to Auto On ( )
Touch test area and
look for the SafeSense
®
indicator to illuminate
SafeSense
®
is active and
working properly
If hand is held on SafeSense
®
area more than 3 seconds
shredder will shut off
SAFESENSE
®
TECHNOLOGY
Stops shredding immediately when hands touch the
paper opening.
WHEN IN SLEEP MODE
ENERGY SAVING SYSTEM
• Saves energy in four ways: energy-efficient electronics, jam prevention,
standby mode and sleep mode.
• Sleep Mode shuts down shredder after 2 minutes of inactivity.
Optimal energy efficiency 100% of
the time – in use and out of use.
In sleep mode
To get out of sleep mode
set to OFF ( ), then
Auto On ( )
Insert paper
or
For more information about all of Fellowes Advanced Product Features go to
www.fellowes.com
JAM BLOCKER
TM
ADVANCED PRODUCT FEATURES
Blocks jams before they start
If Remove Paper
icon illuminates during the shredding process
(due to paper misfeed or wrinkle) follow the procedures below.
Patented SafeSense
®
Technology
Stops shredding immediately when
hands touch the paper opening
Jam Blocker
TM
Blocks jams before
they start
Reduce paper quantity
to an acceptable
amount and refeed
into paper entry
Set to Reverse (
)
and remove paper
Set to Auto On ( ) and
refeed into paper entry
Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.
15
15
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
PRODUCT MAINTENANCE
All cross-cut shredders require oil for peak performance.
If not oiled, a machine may experience diminished sheet
capacity, intrusive noise when shredding and could ultimately
stop running. To avoid these problems, we recommend you
oil your shredder each time you empty your waste bin.
OILING SHREDDER
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
*Apply oil across entry
Set to OFF ( )
Set to Reverse (
)
for 2-3 seconds
TROUBLESHOOTING
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This
indicator will remain illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about
the continuous operation and recovery time for this shredder.
Bin Open/Bin Full: The shredder will not run if the bin is open or full. When illuminated, close or empty the bin to resume shredding.
Remove Paper: When illuminated, set to reverse (
) and remove paper. Reduce paper quantity to an acceptable amount and refeed into paper entry.
SafeSense
®
Indicator: If hands are too close to the paper entry, the SafeSense
®
indicator will illuminate and the shredder will stop shredding. If SafeSense
®
is active for 3 seconds, the shredder will automatically turn off and the user must set the switch to OFF ( ), then Auto On ( ) to resume shredding.
1
2
Shredder pauses for
3 seconds
3
Energy Saving System
Optimal energy efficiency 100% of
the time – in use and out of use.
2
1
3
If Remove Paper icon ( )
is illuminated, there is too
much paper for the shredder
to power through
2
1
3
1
3
4
2
1
2
