2
CAPABILITIES
Will shred:
Paper, plastic credit cards*, staples* and small paper clips*
*Manual Feed
Will not shred:
Adhesive labels, CD/DVDs, continuous form paper, transparencies,
newspaper, cardboard, large paper clips, laminates, file folders, X-rays or plastic other than
noted above
Paper shred size:
Micro-Cut .................................................................5/32 in. x 25/64 in. (4mm x 10mm)
Maximum:
Sheets per pass (Auto Feed) ....................................................................................... 100*
Sheets per pass (Manual Feed) .................................................................................... 10*
Cards per pass ............................................................................................................... 1*
Paper entry width .....................................................................................8.7 in. (220mm)
* 8.5 in. x 11 in., 20lb., (75g)
paper at 120V/60 Hz, 3.5Amps; heavier paper, humidity
or other than rated voltage may reduce capacity. Recommended daily usage rates:
1,000 sheets; 15 credit cards.
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
ENGLISH
Model 100M
KEY FEATURES AND CONTROLS
A. Auto Feed Tray
B. Auto Feed Flap
C. Disconnect Power Switch
1. OFF
2.
ON
D. Manual Feed Slot
E. Pull-Out Bin
F. Casters
G. Auto Feed Tray Extension
H. See Safety Instructions
I. Control Panel and LEDs
1.
Reverse
2. ON/OFF and Start (blue)/Bin Open
3. Remove Paper (red)
4. Bin Full (red)
5. Overheat (red)
BASIC SET UP
CASTER INSTALLATION
1
3
4
2
C.
B.
A.
I
H.
F.
D.
E.
G.
t 0QFSBUJPONBJOUFOBODFBOETFSWJDFSFRVJSFNFOUTBSFDPWFSFEJOUIF
instruction manual. Read the entire instruction manual before operating
shredders.
t ,FFQBXBZGSPNDIJMESFOBOEQFUT,FFQIBOETBXBZGSPNQBQFSFOUSZ
Always set to off or unplug when not in use.
t ,FFQGPSFJHOPCKFDUToHMPWFTKFXFMSZDMPUIJOHIBJSFUDoBXBZGSPN
shredder openings. If object enters top opening, switch to Reverse (
)
to back out object.
t
DO NOT use aerosol products, petroleum based or aerosol lubricants on or
near shredder. DO NOT USE “CANNED AIR” OR “AIR DUSTERS” ON SHREDDER.
Vapors from propellants and petroleum based lubricants may combust causing
serious injury.
t %POPUVTFJGEBNBHFEPSEFGFDUJWF%POPUEJTBTTFNCMFTISFEEFS%POPU
place near or over heat source or water.
t .PWJOHQBSUTEPOPUUPVDI
t 5IJTTISFEEFSIBTB%JTDPOOFDU1PXFS4XJUDI $UIBUNVTUCFJOUIF0/ *
position to operate shredder. In case of emergency, move switch to OFF ( )
position. This action will stop shredder immediately.
t "WPJEUPVDIJOHFYQPTFEDVUUJOHCMBEFTVOEFSTISFEEFSIFBE
t 4ISFEEFSNVTUCFQMVHHFEJOUPBQSPQFSMZHSPVOEFEXBMMPVUMFUPSTPDLFUPG
the voltage and amperage designated on the label. The grounded outlet or
socket must be installed near the equipment and easily accessible. Energy
converters, transformers, or extension cords should not be used with this product.
t '*3&)";"3%o%P/05TISFEHSFFUJOHDBSETXJUITPVOEDIJQTPSCBUUFSJFT
t 'PSJOEPPSVTFPOMZ
t 6OQMVHTISFEEFSCFGPSFDMFBOJOHPSTFSWJDJOH
