4
TROUBLESHOOTING
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This indicator
will remain illuminated and the shredder will not operate for the duration of the recovery time.
Bin Open: The shredder will not run if the bin is open. When illuminated, close the bin to resume shredding.
Remove Paper: When illuminated, press reverse (
); open lid and remove paper.
Bin Full: When illuminated, the shredder waste bin is full and needs to be emptied. Use Fellowes waste bag 36053.
PRODUCT MAINTENANCE
TO CLEAN THE SENSORS
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors
may become blocked by paper dust causing the motor to run even if there is no paper present.
(Note: the paper detection sensors is located in the center of the paper entry).
All cross-cut shredders require oil for peak performance. If not oiled, a
machine may experience diminished sheet capacity, intrusive noise when
shredding, and could ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty your waste bin.
OILING SHREDDER
15
15
* Only use a non-aerosol vegetable oil in long
nozzle container such as Fellowes 35250
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
Turn off and unplug
shredder
*Carefully apply oil
across cutters (do not
get oil in paper tray)
Close lid. Press and
hold forward ( )
2-3 seconds
Open lid
Locate Auto-start
infrared sensor
Using cotton swab,
wipe away any
contamination from
the paper sensors
Dip cotton swab in
rubbing alcohol
4
Open lid
1
3
1
2
5
3
ADvANCED PRODUCT FEATURES
For more information about all of Fellowes Advanced Product Features go to
www.fellowes.com
SilentShred
™
Technology
SilentShred™ noise quality
shreds without noisy disruptions.
Energy Saving Sleep Mode
Feature shuts down the shredder
after 2 minutes of inactivity
WHEN IN SLEEP MODE
To get out of sleep mode,
open lid and load paper
Insert paper
or
SLEEP MODE OPERATION
Feature shuts down the shredder after 2 minutes
of inactivity
2
1
2
* Shredder will not run when lid is open.
MISALIGNED PAPER
If paper is not shredding
through auto feed tray,
check position of paper.
Paper should be flat and
aligned with front of
paper tray.
1
2
