9
Intensity Key: • Press key to set flashlamp intensity to
100%, 66%, or 33% level
The maximum flash rate is automatically limited by the selected
intensity level as follow:
100% intensity = 100F/S Max - 6000 F/M
66% Intensity = 200 F/S Max - 12000 F/M
33% Intensity = 300 F/S Max - 18000 F/M
• Indicates selection of Flashes/Sec units for flash rate display.
• Indicates selection of Flashes/Min units for flash rate display.
• Indicates Phase Delay setting when operating from external trigger signals
.
• Phase Delay mode can only be selected when an external trigger cable
is connected to the PowerStrobe trigger input connector.
• When operating in Phase Delay mode, the flash rate display shows the
phase delay from 0° to 360° set by the Up & Down rate keys.
• Five Digit Display for indicating the flash rate set by the Up & Down rate
keys, or phase delay when selected.
• Intensity indicator for displaying selected intensity level (100%,66% 33%)
•External Trigger indicator
- illuminates when an external trigger cable is connected.
- blinks when the external trigger rate exceeds the max flash rate for the
selected intensity range.
• Fan Fault indicator
- illuminates if the internal cooling fan fails to operate.
A fan fault condition automatically shuts down the PowerStrobe flash lamp circuit.
• Low Battery indicator - blinks when the DC Power Pack requires recharging.
