1. Insert yoke (A) into top 3” hem of motor cover.
2. Attach yoke to yoke bracket using two (2) 1/4” x 3/4”
bolts and nuts
3. Attach yoke to door post using one (1) 1/4” x 1” bolt
and nut.
Note
: Head of bolt inside, nut outside.
4. Tighten
center bolts only.
YOKE
A
1. Insert side arm (A) into 3: hem of motor cover.
2. Attach side arm to yoke using one (1) 3/8” x 1” bolt and
nut. Note: Head of bolt up, nut down.
3. Drill a 9?32” diameter hole in fender and attach rear of
side arm using one (1) 1/4” x 3/4” bolt, fender washer,
and nut.
4. Tighten all bolts and snap motor cover around side
arm.
SIDE ARM
A
1. Cut plastic Dual Lock® into 2” lengths.
2. Surface must be cleaned with a mild detergent to as-
sure proper application of Dual Lock® strips.
NOTE: Do not peel the backing from the Dual Lock® .
3. Apply cut Dual Lock® to all Dual Lock® sewn to motor
cover.
4. Arrange motor cover to tractor. Peel backing from Dual
Lock® and apply to tractor. Repeat this procedure for
all Dual Lock® .
DUAL LOCK®
is a registered trademark of the 3M Co.
