EN
12
6.3 DISPOSAL OF THE MACHINE AND PACKAGING
INFORMATION FOR USERS
Implementation of Directives
2011/65/EU
- 2012/19/EU
, relative to reducing the use
of hazardous substances in electrical and
electronic appliances and the disposal of waste”, please take
note of the following:
• The crossed out wheelie bin symbol found on the
appliance or on the packaging, indicates that the product
must be disposed of separately from ordinary household
waste when it reaches the end of its working life.
• The user must consign the unwanted appliance to
an authorized diff erentiated waste disposal centre for
electrical and electronic goods, or alternatively, hand
it over to the relative dealer on purchasing a new
appliance of the same type on the basis of a one to
one ratio.
1 Faulty motor, power supply
cable or plug.
2 Burned out fuses
1 Low power supply voltage.
2 Damaged windings.
3 Burned out capacitor
1 Damaged windings.
2 Faulty motor
1. O v e r l o a d e d c i r c u i t d u e
to lighting, utilities or other
motors
1 Overloaded motor.
2 Insuffi cient motor cooling
1. The blade has been repeatedly
sharpened and its diameter has
decreased
1. The blade is worn out or the
teeth are not suited to the
thickness of the material being
cut
1. The blade’s teeth are not suited
to the workpiece
1 Have the machine checked by skilled
personnel.
Do not try to repair the machine yourselves as it
may be dangerous.
2 Check the fuses and replace them if necessary.
1 Ask for the Electricity Board to check the voltage
available.
2 Have the machine motor checked by skilled
personnel.
3 Have the capacitor replaced by skilled
personnel.
1. Have the motor checked by skilled personnel
1. Do not use other utilities or motors on the circuit
to which the cutting-off machine is connected
1 Avoid overloading the motor during cutting.
2 Remove dust from the motor in order to allow
adequate cooling.
1. Adjust the limit switch for the lowering of the
head.
1 Have the blade sharpened by skilled personnel.
2 Check that the blade being used is appropriate by
refering to the paragraph ‘SELECTION OF THE
BLADE’.
1. Check the appropriate teeth to use by refering to
the paragraph ‘SELECTION OF THE BLADE’
The motor does not run
The motor starts slowly
and does not reach
running speed
Excessive motor noise
The motor does not
reach full power
The motor tends to
overheat
Decrease in cutting
capacity
The cutting fi nish is
irregular or uneven
Flaking of the
workpiece
PROBLEMS
CAUSES
SOLUTIONS SUGGESTED
• Diff erentiated disposal, to enable possible recycling or
environmentally compatible elimination of the appliance,
helps to limit undesirable eff ects on health and the
environment and promotes the reuse and/or recycling of
the materials which went into making up the appliance.
ATTENTION! Sanctions, in accordance with the
relative legislation in force in the country of use,
will be imposed on the user if the appliance is
disposed of illegally.
7
TROUBLESHOOTING
