14
8.
CONTROL
ON/OFF AND POWER OUTPUT SWITCHING PUSH BUTTON
As with DUO PD power models, large control push button is used for basic control. The ON /
OFF switch push button has extended functionality, which is used for switching the energizer
power output. After switching off and then switching on again, the energizer remembers the
last set power output.
ENERGIZER IS SWITCHED OFF; BY PRESSING PUSH BUTTON:
Long press (>2 s)
Energizer is switched on
Short press
No response
ENERGIZER IS SWITCHED ON; BY PRESSING PUSH BUTTON:
Long press (>2 s)
Manual switching between the high and low power
output (approximately 50%).
User selectable; when, for example, it is used for
more sensitive animals or to reduce demand on battery, if required. The low power
output is always limited to the maximum of 5 J.
Short press
Energizer is put into the Standby Mode
ENERGIZER IS IN STANDBY MODE; BY PRESSING PUSH BUTTON:
Short press
Energizer is fully switched off
Long press (>2 s)
Energizer is switched on
If a dash is displayed on the energizer display next to measuring the quality of earthing symbol
it indicates either that the measuring electrode is not connected to the green output or that the
fence system wire is not short-circuited (if fence system impedance is higher than 500 Ohm).