TM
L
M
N O
P
Q
R
S
T
K. TREBLE
- Adjusts the amount of high frequency boost or cut in the Drive channel. This control is post
distortion and is useful in adjusting the distortion from smooth to brash.
L. MID
- Adjusts the overall tone quality of the DRIVE channel . High Mid settings will emphasize mid
frequencies. A lower setting will notch the midrange to produce the “crunch” sound
characteristic in most heavy metal music.
M. BASS
- Adjusts the amount of low frequency boost or cut in the Drive channel. This control is post
distortion and is useful for adjusting the amount of “thump” or “chunk” produced by the drive channel.
N. DRIVE SELECT
- When this button is depressed, the amp switches from the normal channel to the
gain select switch (item H).
O. VOLUME
- Adjusts the overall volume of the drive channel .
P. REVERB
- Adjusts the amount of reverb present in both the Drive and Normal channels.
Q. EFFECTS MIX
- Adjusts the amount of audible effects (wet) signal while using the variable effects loop
(located on the rear panel). Lower effects mix settings will produce less “wet” signal. Depending on the
effects device used, when the effects mix control is set to “10” only the “wet” signal will be heard. With
nothing inserted into the Return Jack (item F), the control is disconnected.
R. FOOTSWITCH (INCLUDED)
- Plug-in connection for a remote footswitch to switch between the normal
and drive channels, red and yellow channels, and to turn the reverb on and off. Using the footswitch over-
rides the front panel select buttons.
NOTE: Any good quality patch cord will work with the remote
footswitch, however, a speaker grade cord is preferable to a coax guitar cord.
S. POWER INDICATOR
- This LED is illuminated when the power is ON.
T. POWER SWITCH
- Turns the AC power ON and OFF.
