9
EDITING AND SAVING EFFECTS CONTROL SETTINGS
To edit and save individual control settings of a preset’s various effects (if any), first select the effect
category
box containing the effect to be edited by turning and pressing the ENCODER. There are four effects category
boxes that can each contain one effect: STOMP (stompbox), MOD (modulation), DELAY and REV (reverb):
The DISPLAY WINDOW will then show a list of controls for the effect model in use in that category; use the EN-
CODER to scroll to a particular effect control. Press the ENCODER to select the effect control; its surrounding
box will turn from blue to red. Turn the ENCODER to set a new value for the selected control value:
At this point, press the ENCODER to accept the adjusted effect control value and exit edit mode; the sur-
rounding box will then return to blue. Alternately, press the BACK utility button (
green arrow
) to accept the
effect control value change and return to the preset contents screen:
IMPORTANT: If an edited effect control setting is not saved, the preset will revert to its original effect control
settings when returning to the preset after leaving it, or when turning the amplifier off and back on again. To
save edited effect control settings, follow the SAVE, SAVE AS or REPLACE instructions on pages 6 and 7.
AMPLIFIER
DELAY
MOD
TWIN CLEAN
STOMP
REV
01 FENDER C...
5.5
5.5
5.5
DECAY
LEVEL
TONE
SMALL ROOM
7.6
7.6
5.5
5.5
DECAY
LEVEL
TONE
SMALL ROOM
7.6
7.6
5.5
5.5
DECAY
LEVEL
TONE
SMALL ROOM
Summary of Contents for Mustang LT25
Page 1: ...EXPANDED OWNER S MANUAL ...
