11
EN
GL
ISH
thermal trouble. The Passport will reset itself as soon as the problem
has been resolved. If the Passport will not reset and the Protect light
stays red even after you've tried different power outlets and given it
time to cool down, take it to an authorized Fender Service Center. If
neither LED illuminates when powered on, check the Fuse in the
Power Socket.
USB Record / Playback
The Passport Venue features an integrated USB playback/record system that allows you to
playback .wav and .mp3 files as well as record .wav audio files using a USB flash drive.
REVERB 2
REVERB 1
L
R
1
2
3
4
5
6
7
8/USB
TONE
VOLUME
REVERB
TONE
TIME
SELECT
LEVEL
LEVEL
LEVEL
LEVEL
LEVEL
LEVEL
LEVEL
LEVEL
HIGH
LOW
REVERB
HIGH
LOW
REVERB
HIGH
LOW
REVERB
HIGH
LOW
REVERB
HIGH
LOW
REVERB
HIGH
LOW
REVERB
HIGH
LOW
REVERB
HIGH
LOW
REVERB
STEREO
OUT
PAD
PAD
PAD
PAD
STEREO
L / MONO
RIGHT
STEREO
LINE
MIC
PAD
PAD
LINE
MIC
LINE
MIC
LINE
MIC
LINE
MIC
LINE
MIC
RIGHT
L / MONO
SUB OUT
PRE OUT/POWER AMP IN
PHANTOM
POWER
LEVEL
LEFT
RIGHT
POWER
PROTECT
USB
VOLUME
VOLUME
VOLUME
VOLUME
VOLUME
VOLUME
VOLUME
TREBLE
TREBLE
TREBLE
TREBLE
TREBLE
TREBLE
TREBLE
TREBLE
BASS
BASS
BASS
BASS
BASS
BASS
BASS
BASS
REVERB
REVERB
REVERB
REVERB
REVERB
REVERB
REVERB
REVERB
TONE
SELECT
TIME
TONE
1
2
3
4
5
6
7/8
9/10
PHANTOM
POWER
PHONES
OUT
MONO
OUT
LINE
LINE
PAD
PAD
PAD
PAD
INPUT
INPUT
INPUT
INPUT
INPUT
INPUT
SUB
OUT
LEVEL
POWER
PROTECT
STEREO
INPUT
L/MONO
INPUT
RIGHT
INPUT
STEREO
INPUT
L/MONO
INPUT
RIGHT
INPUT
VOLUME
USB
OUTPUT
MASTER VOLUME
REVERB
Use Channel 8 to control USB playback level and tone and use the Channel
8 Signal Indicator
to monitor recording levels.
USB — Plug your USB flash drive in here.
RECORD — Press
to record a new track, then press again
to stop recording. The button will illuminate during recording.
Tracks are recorded in stereo as 16 bit/44.1kHz .wav files.
NOTE:
USB
recording levels are determined by the Channel VOLUME knobs.
If your recording is too quiet, increase the levels on the channels
that are too soft, but be careful, if you hear distortion you have
increased the levels too much!
Tracks recorded to your USB flash drive will be saved with sequential filenames:
"Venue Track 1" then "Venue Track 2," etc. Each recorded track will always be named
sequentially after the last track recorded, even if tracks earlier in the sequence have been
deleted. For example, if you delete "Venue Track 1" but not "Venue Track 2," the next
track recorded will be named "Venue Track 3." NOTE: If a recording exceeds 2GB in size
(approximately 3 hours of recording time) it will be divided into separate, sequentially
named files; a small gap in the recording may be present between files.
PLAY / PAUSE — Press
to play the tracks on your USB flash
drive. Press again to pause playback and the button will flash. Press
and hold
for 2 seconds to stop completely (button turns off).
Pressing
the next time will start playback from the first track
on the USB flash drive.
Tracks on your USB flash drive will play back in alphanumerical order, with the numbered
track titles playing first.
PREVIOUS — Press
to jump to the beginning of the current
track, or within the first 3 seconds of the current track to skip to the
beginning of the previous track. Press and hold
for 2 seconds
for reverse scan.
NEXT — Press
to jump to the beginning of the next track.
Press and hold
for 2 seconds to forward scan.
Erasing Tracks Recorded to Flash Drive:
To erase only the tracks you recorded to the USB flash drive but nothing else: Press and
hold
+
until
starts to blink, then press
. All four buttons will flash
sequentially. To abort the operation before erasing has started, press any button other than
.
Formatting your Flash Drive:
To completely wipe all files from your USB flash drive: Press and hold
+
+
until
&
flash slowly. Then press
once and
&
will flash
rapidly. Press
again and formatting will begin. All four buttons will flash sequentially.
To abort the operation before formatting has started, press either
or
.
Rear Panel
C US
158744
LEFT
RIGHT
SPEAKER OUTPUTS
600W total
4
Ω
MIN 300W
Use only with supplied
4 ohm speakers
Laite on liitett ¨av ¨a suojamaadoituskoskettimilla
va rustettuunpistorasiaan
Apparatet må tilkoples jordet stikkontakt
Apparaten skall anslutas till jordat uttag
TYPE: PR 846
SERIAL NUMBER
ON
OFF
ATTENTION:
UTILISER UN FUSIBLE DE
RECHANGE DE MEME
TYPE ET CALIBRE
CAUTION:
TO REDUCE THE RISK OF
FIRE, REPLACE FUSE WITH
SAME TYPE AND RATING
WARNING:
FENDER AMPLIFIER SYSTEMS
ARE CAPABLE OF PRODUCING
VERY HIGH SOUND PRESSURE
LEVELS WHICH MAY CAUSE
TEMPORARY OR PERMANENT
HEARING DAMAGE. USE CARE
WHEN SET TING AND ADJUSTING
VOLUME LEVELS DURING USE.
750W
INPUT POWER
CAUTION:
CHASSIS SURFACE HOT
WARNING:
TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS EQUIPMENT TO
RAIN OR MOISTURE
AVIS:
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
ATTENTION:
SUPERFICIE DE CHASSIS CHAUDE
T10A H
250V
FUSE
220 - 240V~
50/60Hz
100 -120V~
50/60Hz
A PRODUCT OF:
FENDER MUSICAL INSTRUMENTS CORP.,
CORONA, CA U.S.A.
MADE IN CHINA
THIS DEVICE COMPLIES WITH
PA RT 15 OF FCC R U L E S .
OPERATION IS SUBJECT TO THE
FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE
HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT
ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT
MAY CAUSE UNDESIRED OPERATION.
This product
is covered by
US patent No.
5,933,507
VOLTAGE SELECTOR — Change this setting only if you travel to a
country that requires a different voltage setting.
POWER — Switches the Passport on-off.
POWER SOCKET — Connect to a grounded AC outlet in accordance
with the proper Voltage Selector setting.
FUSE — To replace a failed fuse, unplug the power cord, then pry
the fuse holder out of the Power Socket . Only use a fuse of the
same type and rating.
SPEAKER OUTPUTS — Connect the Passport speakers here using
the cables provided.
Specifications
TYPE:
PR 846
PART NUMBERS:
6947000000 (120V~, 60Hz)
6947000900 (120V~, 60Hz) DS
6947001900 (110V~, 60Hz) TW DS
6947003900 (240V~, 50Hz) AU DS
6947004900 (230V~, 50Hz) UK
6947005900 (220V~, 50Hz) ARG DS
6947006900 (230V~, 50Hz) EU DS
6947007900 (100V~, 50/60Hz) JP DS
6947008900 (220V~, 50/60Hz) CN DS
6947009900 (220V~, 60Hz) ROK DS
6947013900 (240V~, 50Hz) MA DS
POWER REQUIREMENT:
750W
FUSE:
T10A H, 250V
DIMENSIONS:
Height: 23 in (58.4 cm)
Width: 29 in (73.6 cm)
Depth: 11 in (27.9 cm)
WEIGHT:
44 lb (20 kg)
Product specifications are subject to change without notice.
USB Specifications and Formats
USB file format:
FAT16, FAT32
MP3 bit rate:
8k-320Kbps, sample rate: 8K-48kHz, VBR is supported
WAV (PCM) Playback:
8/16bit, sample rate <=48kHz
WAV (PCM) Recording:
16bit, 44.1K sample rate, stereo
For more detailed USB information, log on to
fender.com
and visit the Support area.
