15
In preset view, touch any amp or effect block to modify or replace it. The screen will zoom in on the selected block, allowing access to
block-specific parameters.
EDIT BLOCK
PARAMETERS
CABINET SETTINGS
Turn footswitch to adjust parameter value
REPLACE BLOCK
REMOVE BLOCK
AMP LEVEL
NOISE GATE
Touch a control and slide your finger up or down to set a control to preference. For switches, tap to set to preferred position. Alternately, a
single tap on any individual control knob will activate a gradient slider on the right side of the screen. Slide your finger up or down the gradient
to set the control to preference; use the +/- buttons below the gradient slider for fine tuning. Touch elsewhere on the screen to close the
gradient. Another way to change a block’s parameter settings is to use the rotary control function of the footswitches. When modifying a block,
up to six of its visible control parameters are assigned to the middle six footswitches, with each parameter’s value appearing in the scribble strip
above the footswitch. Turn the footswitch to change the parameter’s setting.
If more than six parameters are available, page dots under the controls will appear, indicating the number of additional pages. Touch the dots
to access additional pages of parameters. Touch the dots on the last page to return to the first page of parameters. Alternately, press the PAGE
footswitch at upper left to view additional parameter pages (press and hold PAGE footswitch to save modified preset).
Swipe left or right on the touchscreen to move to adjacent blocks in signal path for modification. This applies to all amps and effects in the signal
path. Note that instrument and mic/line signal paths are completely separate for swiping. For example, in a preset with active instrument and
mic/line signal paths, swiping left or right on the instrument signal path will only show blocks in the instrument signal path. To edit a block in the
same preset in the mic/line signal path, the user must exit
edit mode
and select a block in the mic/line signal path in order to swipe left or right in
that path only. For complex parallel signal paths, swiping order works according to the equivalent series signal path (left/right, top/bottom).
•
BYPASS BLOCK:
To disable a selected block without removing it from the preset, touch BYPASS in the lower ribbon. The bypassed block
will appear grayed-out in the preset view, and the BYPASS button will turn blue in the lower ribbon.
•
REPLACE BLOCK:
selected block with another, touch the Replace symbol ( ) in the lower ribbon and follow the instructions for adding a
block to choose another one.
•
REMOVE BLOCK:
To remove a selected block, touch the trash can symbol ( ) in the lower ribbon.
At any time, touch the back arrow at left in the upper ribbon to return to preset view.
Press to access
more parameter
pages; press and
hold to save a
modified preset.
