Fenix AT-05B, Instructions Manual

15

15

ENGLISH

9. In case the lifting tower gets blocked at 

any point during lowering process, there are 

two options to try to unlock it. The first will 

always be to raise all profiles to its maximum 

to try to untangle the cable and release the 

lifting tower. The other option will be if the 

problem is due to the pendulum gets stuck in 

one of the profiles. In this case, the solution 

will be to release it by a sharp knock, using 

if possible, an allen key in L, or any screw-

driver. Put the allen key in the lower slot of 

the profile (N) that has been stuck and hit the 

pendulum with a hammer, trying to unlock it 

and release the lifting tower.
10. Lowering: To lower the profiles, follow 

the opposite order. The first profile to be 

lowered will always be the one located clo-

sest to the winch. To release the safety pins 

(A), the load must be lifted slightly with the 

winch. In the normal working position, the 

weight of the load prevents the safety pins 

(A) from being released. Once the safety pin 

(A) is released, move it to the open position 

(T), by doing (U) step. Then turn the winch 

handle (B) slightly counterclockwise. Imme-

diately afterwards, move again the safety pin 

(A) to closed position (S), until the end of the 

section. Repeat the same steps successively 

until it is completely folded to its minimum 

height.
11. For the lifting tower transport, it is neces-

sary to bring down all profiles and place the 

safety pins (A) in closed position (S). Move 

the forklifts (E) in vertical position and lower 

the carriage (X) by turning the winch handle 

(B) and pressing down a little on the carriage 

(X). Place the outriggers (H) in their trans-

port support (C) and retighten the plastic 

knob (V). Fix the forklift (E) by placing the 

pin (L) into the transport plate (F), securing 

the carriage (X) to avoid the block of the pen-

dulum.

5. MAINTENANCE

1. Periodically check cable status. If the ca-

ble seems to have broken wires or crushing, 

replace immediately with a new one. Never 

use the lifting tower with cables in bad con-

ditions. Only use galvanized steel under EN 

12385-4. Cable maximum load: 2.000kg. Ca-

ble torsion resistance: 1.770N/mm². Cable 

diameter: 6mm. Cable composition: 6x19+1.
2. The lifting tower is supplied fully greased 

from factory. Nevertheless, the crown gear of 

the winch, to the threaded bar of the stabili-

ser outriggers and the profiles, because of its 

use periodical greasing is recommended.

WARNING:

DO NOT GREASE OR LUBRICATE BRA-

KING  MECHANISM

Braking disks were greased with a special 

heat and pressure resistant grease. No other 

product must be used to prevent negative in-

fluence on brake functioning.
3. Lifting tower AT-06B, must be checked by 

an expert a minimum of once a year as per 

its use.

4. Only original spare parts must be used to 

ensure continued safe use. The user loses all 

guarantee rights if spare parts other than the 

originals are incorporated or the product is 

modified in any way.
5. To request any spare part, contact the 

manufacturer or an authorised distributor 

within your territory.