Fenix AT-06B, Instructions Manual

14

14

ENGLISH

4. HOW TO USE

1. Place the lifting tower over a firm and flat 

surface on its working place.
2. Remove the outriggers (H) from their 

transport supports (C) by releasing the plas-

tic knob (V) and pull the outrigger (H) up. 

Insert them into their working position (G) 

checking that they are fixed by the safety pins 

(K). The longest outriggers must be placed at 

the front, under the load.
3. Remove the pin (L) from the transport 

plate (F) and remove the forklift (E). Turn 

the winch handle (B) until the carriage (X) 

has raised enough that it does not touch the 

transport plate (F). Put the forklifts (E) in 

horizontal position and secure them with the 

pin (L).
4. Insert the outriggers (H) into their wor-

king position (G) checking that they are fixed 

by the safety pins (K). The longest outriggers 

must be placed at the front, under the load.
5. Adjust the lifting tower using the support 

plates (J) by turning the crank (I) of the re-

gulating rod until it is level, checking the sta-

bilizing bubble level (Y) located at the base.
6. Put the load as close to the lifting tower as 

possible. Do not unnecessarily separate the 

sound system from the lifting tower body to 

avoid overloading. See fig. 2 (page 17). Fo-

llow loading instructions. See fig. 3 (page 17).

.

7. Elevation: To lift the profiles, a specific or-

der must be followed. The first profile to be 

raised will always be the one located furthest 

from the winch. Release the safety pin (A) in 

open position (T) and turn the winch handle 

(B) clockwise, lifting the load until the desi-

red height. Immediately afterwards, close the 

safety pin (A) in position (S), until the end of 

the section has been reached. Go on succes-

sively to the different positions of each of the 

profiles, until the desired height is reached. In 

case the pin is hard to pull out, a small num-

ber of movements should be made with the 

winch until founding the right position whe-

re the pin is released and can be pulled out 

comfortably. Under no circumstances any of 

the pins should be pulled with force. In case 

of the lifting tower does not need to be raised 

to its maximum height, it is recommended to 

raise all the profiles proportionally according 

to the height, and not only one of them.
8. When using the lifting tower outdoors, the 

risk of wind is prevalent, for which there are 

two fixing side rings (M) in the upper part 

of the second profile, where safety cables 

must be attached and fixed on a secure and 

firm surface (never on a vehicle or anything 

that can move). When wind speed exceeds 

30km/h, it is mandatory to bring down the 

lifting tower.

9

S

A

C

J

G

M

B

X

I

H

V

K

F

Y

E

L

U

T