Reverse polarity protection to protect improper battery insertion.
One-switch control ensures easy and fast operation.
Low-voltage warning reminds when battery replacement needed.
Made of quality aluminum and silicone - tough and durable.
Operating Instruction ①
On/off
Press and hold the switch for 0.5 seconds to turn on/off the light.
Output Selection
With the lamp switched on, single click the switch to cycle through Low→Med→High.
Note: Low mode is activated by default when the lamp is turned on.
Battery Specifications
Type
Dimensions
Nominal
Voltage
Usability
Ni-MH Battery
AA
1.2V
Recommended
√√
Alkaline Battery
AA
1.5V
Usable
√
Non-rechargeable Battery
(Lithium)
AA
1.5V
Caution*
！
Rechargeable Battery (Li-
ion)
14500
3.7V
Banned
×
*Disposable lithium battery: it can be used if the voltage is below 1.5V; or it may cause damage
to the lamp if the voltage exceeds 1.5V.
Warning: 1. Do not use the banned battery in case of circuit component damage that is resulted
from overvoltage burnout.
2. If the lamp will not be used for an extended period, remove the battery from the lamp in case
of damage by electrolyte leakage.
Battery Replacement ②
Unscrew the battery cap to insert the battery in accordance with the polarity marks, then
screw the battery cap back on.
Low Voltage Warning
With the lamp switched on, and the voltage level drops below the preset level, the lamp is
programmed to downshift to a lower brightness level until low output is reached. When this
happens in low output, the lamp blinks to remind you to replace the battery. To ensure normal
use, the lamp will not turn off automatically and will work till the battery level runs out.
