Fenix MEGARA 230, Instructions Manual

14

14

ENGLISH

4. HOW TO USE

1. Place the lifting tower over a firm and flat 

surface on its working place.
2. Remove the outriggers (H) from their 

transport supports (C) by pressing the safety 

pins (K) and insert them into their working 

position (G) checking that they are fixed by 

the safety pins (K). 
3. Adjust the lifting tower vertically using the 

support plates (J) by turning the cranks (I) of 

the regulating rod until it is leveled, checking 

the stabilizing bubble level (Y) located at the 

base.
4. Put the load on the top of the lifting tower 

using the suitable support, in order to make 

the load work only vertically. The minimum 

load must be 25kg.
5. Elevation: To lift the bars, follow a descen-

ding order, that is to say, the first bar to be lif-

ted will be always the highest one. Release the 

safety pin (A) in open position (T) and turn 

the winch handle (B) clockwise, lifting the 

load until the desired height. Immediately 

afterwards, move the safety pin (A) to clo-

sed position (S), until the end of the section 

has been reached. Go on successively to the 

different positions of each of the bars, until 

the desired height is reached. In case the pin 

is hard to pull out, a small number of move-

ments should be made with the winch until 

founding the right position where the pin 

is released and can be pulled out comforta-

bly. Under no circumstances any of the pins 

should be pulled with force. In case of the lif-

ting tower does not need to be raised to its 

maximum height, it is recommended to raise 

all the bars proportionally according to the 

height, and not only one of them.

6. Lowering: Follow an ascending order to 

lower the bars, that is to say, the first bar to 

be lowered will be the lowest one. To relea-

se the safety pins (A), the load must be lifted 

slightly with the winch. In the normal wor-

king position, the weight of the load prevents 

the safety pins (A) from being released. Once 

the safety pin (A) is released, move it to the 

open position (T), by doing (U) step. Then 

turn the winch handle (B) slightly counter-

clockwise. Immediately afterwards, move 

again the safety pin (A) to closed position 

(S), until the end of the section. Repeat the 

same steps successively until it is completely 

folded to its minimum height.
7. For the lifting tower transport, it is neces-

sary to bring down all bars and place the sa-

fety pins (A) in closed position (S). Place the 

outriggers (H) in their transport support (C) 

checking that the safety pins (K) are fixed in 

its correct position.