3
UNPACKING INSTRUCTION
CAUTION!
Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must be
returned, it is important that the product is returned in the original factory box and packaging.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
OVERVIEW
1. Tone arm Lever
The fixed tonearm can be raised and lowered pressing the raise / lower
lever.
2. Tone arm
3. 33 / 45 / 78 RPM Switch
This switch controls the RPM of the turntable platter.
4. Autostop Switch ON/OFF
This switch turns auto stop on or off. When the automatic stop is
enabled, the platform will start rotating as soon as the tone arm is placed
over the record and will stop rotating when it has reached the end of the
record. Some vinyl records stop before the end or do not stop when the
end is reached. In this case set Auto-stop to OFF.
5. Tone arm Clip
This clip secures the tonearm while at rest or when not in use.
6.
Cartridge with Needle
When the turntable is not in use, it is recommendable to place the
removable protection cover on the stylus.
7. Volume Control
Adjust the volume for the speakers.
8. LED Indicator
Indicator lights up when power turned on.
9. Mode
Select the BT or phono play function.
10. Platter
Place your record here.
11. 45RPM Adapter
12. DC IN port
Connecting the 12Volt/DC power adaptor.
13. Line Output
The audio from a playing vinyl record is sent to this line-level coaxial audio output. This must not be connected to phono
level devices.
14. USB Port
Use the included USB cable to connect your turntable to your computer. The USB connection will send audio signal from the
turntable to your computer.
OPERATION
1.
Switch the function mode (9) to PH. Turn on the power switch at the rear of the turntable player. The indicator will emit red
colour.
2.
Place a record on the turntable platter and select the desired speed (33/45/78RPM) according to the record.
NOTE:
when playing a 45RPM record, use the included 45RPM adapter located inside the accessories bag.
3.
Remove the stylus protector. Open the tone-arm clip to release the tone-arm. Push the lift lever backward to raise the tone-
arm and gently move the tone-arm to the desired position over the record. The turntable will begin to spin when the arm is
moved toward the record. Push the lift lever forward to lower the tone-arm slowly onto the desired position on the record to
begin playing the record.
NOTE:
-The record will begin to spin only when the tone-arm is moved toward the record if the Auto Stop is turned on.
- AUTO STOP function applies to most 33RPM vinyl records. However, for very few vinyl records, it will stop when it did
not yet reach the end (in this case, turn the AUTO STOP switch to OFF position and then it will continue playback), or it
will not stop when it has reached the end when AUTO STOP is ON.
4.
Turn the Volume Control Knob to adjust the volume.
CONNECT BT-DEVICE
1.
Switch the function mode (9) to BT. The LED indicator will flash in blue colour.
2.
Turn on the BT function of your mobile phone, tablet or other BT device and search the turntable
player with its name Fenton recordplayer.
3.
After pairing and connection, the LED indicator will stop flashing. You can play your music from
your BT-device.
4.
Turn the volume control knob to adjust the volume.
