3
OVERVIEW
1. Platter
Place your record here.
2. 45RPM Adaptor
This adaptor allows you to play 45RPM records.
3. Tone arm Lever
Raises and lowers the tonearm.
4. Tone arm
The fixed tonearm can be raised and lowered by hand, or by pressing the raise / lower lever.
5. Autostop Switch ON/OFF
This switch turns auto stop on or off. When auto stop is on, the platter will start spinning when the tonearm is placed
over the record and stop spinning when the record has reached the end.
6. 33 / 45 / 78 RPM Switch
This switch controls the RPM of the turntable platter.
7. Tone arm Clip
This specially designed arm clip secures the tonearm while at rest or when not in use.
8. Cartridge with needle
When the turntable is not in use, it is recommendable to place the removable protection cover on the stylus.
9. Autostop Switch ON/OFF
This switch turns auto stop on or off. When auto stop is on, the platter will start spinning when the tonearm is placed
over the record and stop spinning when the record has reached the end.
10.
USB port
Use the included USB cable to connect your turntable to your computer. The USB connection will send audio from the
turntable to your computer.
11. Headphone input
Connect your headphone with this 3.5mm(1/8) jack connector.
12.
DC IN port
Connecting the 5Volt/DC power adaptor.
13. Line output
The audio from a playing vinyl record is sent to this line-level coaxial audio output. This must not be connected to
phono level devices.
OPERATION
1.
Connect the record player with the power adapter and plug the other end into a wall power outlet.
2.
Remove white protective needle cover by gently pulling towards the front of the unit.
3.
Place a vinyl record on the turntable platter and select the desired speed (33/45RPM) according
to the record.
4.
Open the tone arm clip to release the tone arm. Gently move the tone arm and put the cartridge
onto the desired position of the record and the turntable player starts to play.
5.
Turn the volume control knob clockwise to adjust the volume.
Noted:
If the AUTO STOP ON/OFF Switch is turned ON, the record will stop automatically when finished. If Auto Stop Control is
turned OFF, record will NOT stop automatically when finished.
