®
AVALLON.COM
©2021 Ferguson Enterprises, LLC V1.0-10132021
11
Leveling the Refrigerator
The refrigerator should be installed on a firm and level surface
that will be able to support the entire weight of a fully loaded unit.
It is important for the refrigerator to be leveled in order to work
properly. It can be raised or lowered by rotating the plastic sheaths
around each of the feet on the bottom of the machine. If you find
that the surface is not level, rotate the feet until the refrigerator
becomes level. You may need to make several adjustments to
level it. We recommend using a carpenter’s level to check the
machine. Turn the leveling feet to the right to lower that side of the
refrigerator. Turn the leveling feet to the left to raise that side of the
refrigerator.
up
down
Installing the Door Handle
To install the door handle:
1. Open the door and carefully pull the door gasket around the area where the handle is to be
installed.
2. Insert each Phillips head screw through the gasket side of the door until the screw passes through
the door.
3. Align the handle with the screws and tighten using a Phillips head screwdriver until the handle is
flush against the door frame.
4. Carefully press the door gasket into its original position.
CAUTION:
Do not over-tighten the screws as this may cause damage to the handle or to the stainless
steel door.
NOTE:
Once you are ready to install the unit in a cabinet or directly on the floor, you must adjust the feet
to level the refrigerator.
