®
AVALLON.COM
©2021 Ferguson Enterprises, LLC V1.0-10132021
9
Clearance Requirements
When building in the refrigerator, follow the recommended spacing dimensions shown.
To ensure proper service access and ventilation, allow at least 1-2” of clearance at the back,
1
/
4
” at the
top, and
1
/
4
” at the sides. If the door side is against a wall, allow at least 2
1
/
16
” of clearance. The installation
should allow the unit to be pulled forward for servicing, if necessary.
90
Door Swing
1 13/
16
“
24
3
/
4
"
2 1/16”
1-2”
1/4”
1/4”
1/4”
1 - 2”
Top View:
Side View:
NOTES:
• The refrigerator should be installed on a firm and level surface that will be able to support the
entire weight of a fully loaded unit. It is important for the refrigerator to be level in order to work
properly. If needed, you can adjust the height of the refrigerator by rotating the feet. See the
“Leveling the Refrigerator” section.
• A standard electrical supply (115 VAC only, 60 Hz), properly grounded in accordance with National
Electrical Code and local codes and ordinances, is required.
• To ensure proper service access and ventilation, allow between 1 - 2 inches of clearance at the
back as shown in the diagram.
• The installation should allow the unit to be pulled forward for servicing, if necessary.
• A standard electrical supply (115 VAC only, 60 Hz), properly grounded in accordance with
National Electrical Code and local codes and ordinances, is required.
NOTES:
