I.
GENERAL INFORMATION
[11]
6.5
Connecting to your network
Ethernet RJ45 connector
Connect your device to the network with
an Ethernet cable.
NOTE:
To operate all features of your
device connect your device to your
network via a Router which is connected
to the Internet. If you cannot connect to
your network or if ‘Connection failed!’ is
displayed for network features check
again the address and the network
connection and try again.
7.
Inserting the batteries
Insert the batteries (2 x AAA 1.5V) into the remote control unit according to the
polarity.
8.
Powering On/Off
Power ON/Booting
Connect the power cord of your device to a mains socket. Turn
On
the mains switch
on the rear panel to start the booting.
Standby
Press the
STANDBY
key to switch between
standby
and
operation
mode. Timer
recordings will record in this mode.
Deep Standby
Hold the
STANDBY
key pressed for
5 seconds
to switch to the
Deep
Standby
mode. To switch again to operation mode, press the
STANDBY
key again. Timer recordings will not record in this mode.
