EN
3
Ferm
WET & dry bEnch grindEr
The numbers in the following text refer to the
drawing on page 2
For your own safety and for the safety of
others, please read these instructions
carefully before using this appliance. It
will help you understand your product
more easily and avoid unnecessary
risks. Keep this instruction manual in a
safe place for future use.
contents:
1. Machine data
2. Safety instructions
3. Installation
4. Operation
5. Maintenance
1. Machine data
Technical specification
Voltage
230 V~
Frequency
50 Hz
Power input
250 W S2=30 min.
No load speed
2950/min
Grinding stone dimensions
Ø 150x20 (12.7) mm
Wet grinding stone dimensions
Ø 200x40 (20) mm
Weight
8.5 kg
Lpa (sound pressure level)
62.6 +3 dB(A)
Lwa (acoustic power)
75.6 +3 db(A)
Vibration
< 2.5 m/s
2
Load factor
A load factor of S2 = 30 min (intermittent periodic
duty) means that you may operate the motor
continuously at its nominal power level for no
longer than the time stipulated on the
specifications label (30 minutes ON period). If you
fail to observe this time limit the motor will
overheat. During the OFF period the motor will
cool again to its starting temperature.
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given in EN
60745; it may be used to compare one tool with
another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned
• using the tool for different applications, or with
different or poorly maintainted accessories,
may significantly increase the exposure level
• the times when the tool is switched off or when
it is running but not actually doing the job, may
signifi cantly reduce the exposure level
Protect yourself against the effects of
vibration by maintaining the tool and its
accessories, keeping your hands warm, and
organizing your work patterns.
contents of packing
1 Wet & dry bench grinder
1 Sets eye shield b eye shield
1 Tool rest
1 Users manual
1 Guarantee card
Check the machine, loose parts and accessories
for transport damage.
Features
Fig. A
1. On/off switch
2. Support
3. Cover glass
4. Cover glass holder
5. Screw
6. Grinding stone wet
7. Water reservoir
2. Safety instructions
In this manual and/or on the machine the following
symbols are used:
Denotes risk of personal injury, loss of
life or damage to the tool in case of non-
observance of the instructions in this
manual.
Indicates electrical shock hazard.
Immediately unplug the plug from the
mains electricity in the case that the
cord gets damaged and during
maintenance
Keep bystanders away
