6
EN
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns.
Description
The numbers in the text refer to the diagrams on
pages 2-3
Fig. A
1. Machine
2. Charging socket
3. Charging indication light
4. Bit holder
5. Direction switch
6. On / off switch
7. Work light
8. Charger adaptor
10. Screw driver bit
3. OPERATING
The machine must be charged before
first use.
Charging the machine
• Plug the small cable plug (8A) into the
machine’s charging socket (2).
• Plug the charger into an electrical outlet
and wait for a while. The LED indicator on
the machine (3) will lighten up and show the
charging status.
Charging indication light (3)
Fig.A
The machine has a charging indication light
(3) which indicates the status of the charging
process:
LED color Status
Red
Battery charging in progress
Red+Green Battery charging finished, battery fully charged
• Fully charging the battery may take up to 3 - 5
hours.
Fitting and removing drills or screwdriver bits
Fig. B
The machine bit holder (4) is suitable for drills
and screwdriver bits with a standard ¼ inch.
hexagonal shaft. To fit a screwdriver bit:
• Insert the screw driver bit (10) into the
machine’s bit holder (4), it will be hold by a
magnet.
• The screw driver bit can be removed by pulling
it out of the bit holder again.
Adjusting the direction of rotation
Fig. A
• Set the direction switch (5) to position ‘
’ in
order to drive screws or to use it for drilling.
• Set the direction switch (5) to position ‘
’ in
order to remove screws.
Switching the machine on and off
Fig. A
• Pressing the on/off switch (6) will activate the
machine.
• Releasing the on/off switch (6) will stop the
machine.
• Move the direction switch (5) to the middle
position to lock the movement of the on/off
switch. It cannot be activated in this position.
The machine is equipped with electronic
overload protection function. When the
machine gets overloaded it will shut
down automatically. When this happens,
please wait for at least 5 seconds to let
the overload protection reset itself.
Spindle lock function
Fig. C
The machine is fitted with an automatic spindle
lock feature. When the on/off switch (6) is not
pressed, the bit holder (4) rotation is locked. Now
it is possible to use the screwdriver (even when
the battery is empty) as a manual tool.
