Ferm CDM1165 Original Instructions Manual Download

Page: 5 / 84

Use power tools only with speci

cally

designated battery packs.

Use of any other

battery packs may create a risk of injury and

re.

When battery pack is not in use, keep it
away from other metal objects, like paper
clips, coins, keys, nails, screws or other
small metal objects that can make a
connection from one terminal to another

Shorting the battery terminals together may
cause burns or a

re.

Under abusive conditions, liquid may be
ejected from the battery; avoid contact.
If contact accidentally occurs,

ush with

water. If liquid contacts eyes, additionally
seek medical help

Liquid ejected from the

battery may cause irritation or burns.

Do not use a battery pack or tool that is
damaged or modi

ed.

Damaged or modi

batteries may exhibit unpredictable behaviour
resulting in

re, explosion or risk of injury.

Do not expose a battery pack or tool to

re or excessive temperature.

Exposure to

re or temperature above 130 °C may cause

explosion. NOTE The temperature „130 °C“
can be replaced by the temperature „265 °F“.

Follow all charging instructions and do not
charge the battery pack or tool outside
the temperature range speci

ed in the

instructions.

Charging improperly or at

temperatures outside the speci

ed range may

damage the battery and increase the risk of

re.

Service

Have your power tool serviced by a
quali

ed repair person using only identical

replacement parts.

This will ensure that the

safety of the power tool is maintained.

Never service damaged battery packs.

Service of battery packs should only be
performed by the manufacturer or authorized
service providers.

Additional safety warnings for drills
and screw drivers

Hold the power tool by insulated gripping
surfaces, when performing an operation
where the cutting accessory or fasteners
may contact hidden wiring.

Cutting

accessory contacting a “live” wire may make

exposed metal parts of the power tool “live”

and could give the operator an electric shock.

”

Safety instructions when using long
drill bits

Never operate at higher speed than the
maximum speed rating of the drill bit.

At higher speeds, the bit is likely to bend if

allowed to rotate freely without contacting the

workpiece, resulting in personal injury.

Always start drilling at low speed and with
the bit tip in contact with the workpiece.

At higher speeds, the bit is likely to bend if

allowed to rotate freely without contacting the

workpiece, resulting in personal injury.

Apply pressure only in direct line with the bit
and do not apply excessive pressure.

Bits

can bend causing breakage or loss of control,

resulting in personal injury.

Residual risks

Even when the power tool is used as
prescribed it is not possible to eliminate all
residual risk factors. The following hazards
may arise in connection with the power tool’s
construction and design:

Health defects resulting from vibration
emission if the power tool is being used
over longer period of time or not adequately
managed and properly maintained.

Injuries and damage to property to due to
broken accessories that are suddenly dashed.

Warning!

This power tool produces an

electromagnetic field during operation.
This field may under some
circumstances interfere with active or
passive medical implants. To reduce the
risk of serious or fatal injury, we
recommend persons with medical
implants to consult their physician and
the medical implant manufacturer before
operating this power tool.

2. MACHINE INFORMATION

Intended use

The impact driver is intended for driving in and
loosening screws and bolts.

Not suitable for construction site usage.