Ferm CDM1165 Original Instructions Manual Download

Page: 7 / 84

4. OPERATION

Adjusting the direction of rotation (Fig. A)

•

Set the direction switch (2) to position “

”

in order to drive screws or to use it for drilling.

•

Set the direction switch (2) to position “

”

in order to remove screws.

Switching the machine on and off (Fig. A)

The on/off switch (3) is used for activating the
machine and adjusting rotation speed.
•

Pressing the on/off switch (3) will activate
the machine, the further the switch is being
pushed, the faster the drill will turn.

•

Releasing the on/off switch (3) will stop the
machine.

•

Move the direction reversing switch (2) to the
middle position to lock the movement of the on/
off switch. It cannot be activated in this position.

Only lay down the machine when it has
stopped running completely. Do not
place it on a dusty surface as particles of
dust could get into the mechanism.

Work light (Fig. A)

The machine is equipped with a work light (6) to
illuminate the work location.
•

It automatically switches on when the on/off
switch is being pressed.

•

It automatically switches off when the on/off
switch is released again.

5. MAINTENANCE

Before cleaning and maintenance, always
switch off the machine and remove the
battery pack from the machine.

Clean the machine casings regularly with a soft
cloth, preferably after each use. Make sure that
the ventilation openings are free of dust and
dirt. Remove very persistent dirt using a soft
cloth moistened with soapsuds. Do not use any
solvents such as gasoline, alcohol, ammonia,
etc. Chemicals such as these will damage the
synthetic components.

ENVIRONMENT

Faulty and/or discarded electrical or
electronic apparatus have to be collected
at the appropriate recycling locations.

Only for EC countries

Do not dispose of power tools into domestic
waste. According to the European Guideline
2012/19/EC for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable must
be collected separately and disposed of in an
environmentally friendly way.

WARRANTY

FERM products are developed to the

highest

quality standards and are guaranteed free of
defects in both materials and workmanship for the
period lawfully stipulated starting from the date
of original purchase. Should the product develop
any failure during this period due to defective
material and/or workmanship then contact your
FERM dealer directly.

The following circumstances are excluded from
this guarantee:
•

Repairs and or alterations have been made
or attempted to the machine by unauthorized
service centers.

•

Normal wear and tear.

•

The tool has been abused, misused or
improperly maintained.

•

Non-original spare parts have been used

This constitutes the sole warranty made by
company either expressed or implied. There are
no other warranties expressed or implied which
extend beyond the face hereof, herein, including
the implied warranties of merchantability and
fitness for a particular purpose. In no event shall
FERM be liable for any incidental or consequential
damages. The dealers remedies shall be limited
to repair or replacement of nonconforming units
or parts.

The product and the user manual are subject
to change. Specifications can be changed
without further notice.