9
EN
Replacing/topping up oil
The compressor has been supplied with synthetic
oil “SAE 10W30”. It is recommend to fully
replace the oil of the pump system within the first
100 operating hours.
• Unscrew the drain plug (gauge) (13) on the
sump lid, let all the oil run out and screw back
the plug (fig. 17).
• Fill the oil via the upper hole of the sump lid
(fig.18) until the level indicated on the gauge
(13) (fig. 8) has been reached.
Check the oil level of the pump system
every week and if necessary top up.
The synthetic oil has the advantage that it
does not lose its characteristics, either in
summer or in winter periods.
For replacement of oil the table below should be
adhered to.
type
Operating hours
Multigrade oil SAE 10W30
100 or 6 months
faults
Should a fault occur, e.g. after wear of a part,
please contact the service address on the
warranty card. In the back of this manual you find
an exploded view showing the parts that can be
ordered.
EnviROnMEnt
To prevent damage during transport, the
appliance is delivered in a solid packaging which
consists largely of reusable material.
Therefore please make use of options for
recycling the packaging.
Faulty and/or discarded electrical or
electronic apparatus have to be collected
at the appropriate recycling locations.
WaRRanty
The warranty conditions can be found on the
separately enclosed warranty card.
Summary of Contents for CRM1045
