EN
5
Before opening the tool, make sure the
tool is disconnected.
To load the tacker
Fig. 3 - 5
Unlocking slide
• Press the slide unlock (2) on both sides to
unlock the slide.
Placing staples
• Pull the slide out of the machine
• Place the staples or nails in the cartridge
Placing nails
• Push the slide back in the machine.
• Lock the slide by sliding the slide forward until
it locks into place.
Using the tacker
• Press the On/Off switch (5) to switch the
machine on
• Press the On/Off switch (5) to switch the
machine off.
Placing the tool
• Place the tool at the spot where the staple or
nail should be located.
• Press the tool down firmly.
Pressing safety catch
• Press the safety catch to the side to unlock
the safety.
Stapling
• Press the switch.
• When the work is completed, slide the safety
catch to the other side to lock the safety back
on.
The tool will cause a re bound because of
the force it operates with. Keep this in
mind.
4. Maintenance
Make sure that the machine is not live
when carrying out maintenance work on
the motor.
This machine has been designed to operate
over a long period of time with a minimum of
maintenance. Continuous satisfactory operation
depends upon proper machine care and regular
cleaning.
Malfunction
Should the machine fail to function correctly, a
number of possible causes and the appropriate
solutions are given below:
• In case a staple or nail is jammed in the tool,
follow the procedure below
• Disconnect the tool.
• Carefully remove the staple or nail from
the tool with a thin object (for example a
knife).
Repairs and servicing should only be
carried out by a qualified technician or
service firm.
Cleaning
Regularly clean the device’s casing with a soft
cloth, preferably after each use. Keep the fan slits
free of dust and dirt. Remove stubborn dirt using
a soft cloth, dampened with soapy water. Do not
use solvents such as benzene, alcohol, ammonia,
etc., which might damage the plastic parts.
Defects
If a defect appears due to a part wearing out,
please contact the service center on the warranty
card. At the end of these instructions there is
an exhaustive overview of the parts that can be
ordered.
Environment
To prevent damage during transport, the
appliance is delivered in a solid packaging which
consists largely of reusable material. Therefore
please make use of options for recycling the
packaging.
Damaged and/or disposed of electrical or
electronic devices must be dropped off at
recycling stations intended for that
purpose.
Only for EC countries
Do not dispose of power tools into domestic
waste. According to the European Guideline
2012/19/EU for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable must
be collected separately and disposed of in an
environmentally friendly way.
Summary of Contents for etm1003
Page 2: ...2 Fig 4 Fig 2 Fig 3 Fig 1 3 4 1 2 Fig 5 Nails N geln spijkers clous...
Page 60: ...PL 60...
Page 62: ...62...
Page 63: ...63...
