Ferm
9
Avoid unintentional starting
Do not carry plugged in tools with your finger on the
switch. Check that the switch is off before plugging in to
socket.
Extension cables
Use only three core earthed extension cables, fitted with
a BS1363 plug with an ASTA approved BS1362 5 amp
fuse, suitable for the power input of the tool (minimum
cable size 1.5mm
2
for 5 metres and 2.5mm
2
for 10 met-
res). Plug into an earthed socket only.
When using a cable reel unwind it fully. Do not use exten-
sion cables over 10m.
Outdoor use extension cables
If the tool is suitable to be used outdoors, use only an
extension cable intended for outdoor use and marked
accordingly. Use a RCD (residual current device) to pro-
vide protection against electrical shock.
Do not use in rain or damp conditions.
Connect a dust extraction device
Whenever there are facilities for fitting a dust extraction
system, make sure it is connected and used.
Use recommended accessories
The use of any other accessory or attachment other than
recommended in the instructions or catalogue may pre-
sent a risk of personal injury.
BEFORE USING THE PILLAR DRILL
Ensure the drill is unplugged from mains and the
drill is switched off.
Refer to illustration page 2.
•
The drill should be mounted on a stable surface and
secured with suitable bolts/screws (not supplied)
through the two holes in the centre of the footplate
(13).
•
Use brackets, nuts, bolts and washers as necessary to
make sure the unit is securely fixed. The footplate is
cast iron, do not over tighten the fixings.
•
Route the mains cable well away from the chuck and
front side of drill, ensure that it cannot get caught in
moving parts or the work piece.
ASSEMBLY
Check package contents
Check contents against list in this manual to make sure
each item is present.
Check for damage
Before using this item check each part listed is undama-
ged.
Save packaging
Save major packaging for return of product for service or
repair.
Assemble Column, Footplate and Table
•
Fasten the column (11) to footplate (13) with the
three-bolts/washers/lock washers provided. Insert
the bolts, with their washers, through the flange on
the column and screw finger tight into threads in
footplate. Tighten with a14mm spanner (not sup-
plied).
•
Slide the table assembly with the degree scale facing
up over the column and lock with the lever (6)
Put the drill head assembly onto the top of the
column
•
Slide the head assembly (7) down until the top of the
column hits the stop.
•
Line up the front of the drill with front face of foot and
secure the drill head with the set pin (8) using the
4mm Allen key provided,
Fitting the chuck guard (3)
•
Fit the chuck guard onto the boss on the chuck
spindle and secure with the bolts/washers/nuts pro-
vided.
Do not operate this drill without the guard in place
and in the down position.
Fitting the drill chuck (9)
•
Put the chuck guard in its upper position. Degrease
the inside of the chuck and the drill spindle using a sui-
table biodegradable solvent, dry off and push the
chuck onto the tapered spindle.
•
Tap the chuck
gently
onto the spindle with a soft face
hammer.
4
Ferm
