Ferm TCM1010, Original Instructions Manual

EN

4

Ferm

Specific safety instructions

• 

Check your powertool for damage before 

starting your work, particularly the diamond 

blade. All parts must be fitted properly and 

must meet all requirements in order to 

guarantee the tool’s smooth operation. Any 

safety guards or any lightly damaged parts 

must be checked to see if they still function 

properly before continuing the use of the tool. 

Moving parts, and the diamond-blade guard in 

particular, must be fitted properly and must not 

jam. Do not use tools that cannot be switched 

on or off with the switch.

• 

The diamond-blade guard must not be 

jammed or removed.

• 

A jamming guard must be repaired 

immediately.

• 

The riving knife must not be removed.

Electrical safety

When using electric machines always observe the 

safety regulations applicable in your country to 

reduce the risk of fire, electric shock and personal 

injury. Read the following safety instructions and 

also the enclosed safety instructions. 

Always check that the power supply 

corresponds to the voltage on the rating 

plate.

Connecting to the power supply

Check that the power supply and plug used in 

accordance with tour tool. Have a look at the rating 

plate on the tile cutter. Any changes should always 

be carried out by a qualified electrician.

 We strongly recommend the use of an 

RCD (Residual Current Device) of not 

more than 30 mA, at the plug socket 

when using  this appliance.

Warning!

 This machine must be earthed.

If not properly earthed this machine can cause an 

electrical shock. Be sure that the power supply 

outlet is earthed. If there is any doubt, have it 

checked by a qualified electrician.

 Warning!

 Avoid contact with the 

terminals on the plug when installing 

(removing) the plug to (from) the power 

supply outlet. Contact will cause a severe 

electrical shock.

Replacing cables or plugs

Immediately throw away old cables or plugs when 

they have been replaced by new ones. It is 

dangerous to insert the plug of a loose cable in the 

wall outlet.

Using extension cables

Only use an approved extension cable suitable for 

the power input of the machine. The minimum 

conductor size is 1.5 mm

2

. When using a cable 

reel always unwind the reel completely.

PRCD

Portable residual current device

Connection to water supply

1)   For tools intended to be connected to a water 

supply, instructions for the connection to the 

water supply, the use of the water and the use 

of attachments to comply with 14.5 in order to 

avoid affection of the tool by water, the 

inspection of hoses and other critical parts 

which could deteriorate and the maximum 

permitted pressure of the water supply.

2)   For tools intended to be connected to a water 

supply, the substance of the following 

instructions, if applicable:

• 

For tools provided with a PRCD: Never use 

the tool without the PRCD delivered with the 

tool,

• 

For tools provided with an isolating 

transformer: Never use the tool without the 

transformer delivered with the tool or of the 

type as specified in these instructions,

• 

Replacement of the plug or the supply cord 

shall always be carried out by the 

manufacturer of the tool or his service 

organisation,

• 

Keep water clear off the electrical parts of the 

tool and away from persons in the working 

area.

3. Assembly

Assembly

Fig.1

• 

Mounting the riving knife.

• 

Unscrew the two (crosshead) screws (9) and 

place the foot of  the riving knife (10) under the 

table.

• 

Place the small plate (2 holes with thread)