Ferm TCM1010, Original Instructions Manual

EN

6

Ferm

replaced.

• 

Type of disk: a diamond blade with a diameter 

of 180mm.

• 

Do not use diamond blades that do not meet 

the specifications in these instructions.

• 

Ensure that the diamond blade is secured 

properly and rotates in the correct direction.

• 

To replace a worn disk, please take the 

following steps (Fig. 2).

Disconnect the plug from the socket.

• 

Remove the water tray (4, Fig. 1) from the 

machine.

• 

Loosen the splash guard’s fixing bolts and 

remove the splash guard.

• 

Loosen the blade fixing nut (4, Fig. 2).

• 

Remove the counter flange (3, Fig. 2) and 

blade (2, Fig. 2) and push the new blade on 

the flange (1, Fig. 2). Consider the rotation 

direction indicated on the blade. Attach the 

counter flange (3, Fig. 2).

• 

Tighten the fixing nut (4, Fig. 2) and the splash 

guard.

• 

Ensure you do not leave any tools lying on the 

splash guard.

5. Service & maintenance

Make sure that the machine is not live 

when carrying out maintenance work on 

the motor. 

The machines have been designed to operate 

over a long period of time with a minimum of 

maintenance. Continuous satisfactory operation 

depends upon proper machine care and regular 

cleaning.

Cleaning

Keep the ventilation slots of the machine clean to 

prevent overheating of the engine.

Regularly clean the machine housing with a soft 

cloth, preferably after each use. Keep the 

ventilation slots free from dust and dirt.

If the dirt does not come off use a soft cloth 

moistened with soapy water. Never use solvents 

such as petrol, alcohol, ammonia water, etc. 

These solvents may damage the plastic parts.

Please clean the tool immediately after use.

Disconnect the plug from the socket.

• 

 Remove the water tray from the machine and 

drain the dirty water.

• 

Unscrew the splash guard and clean it.

• 

Loosen the star-shaped knob, fold up the 

table, and polish the entire machine.

The machine complies with all current safety 

regulations. Repairs may only be carried out by an 

approved company, because repair attempts by 

unqualified people may cause injuries to the user 

and bystanders. Regularly check the plug and the 

cable and if they are damaged they should be 

replaced by an approved company. Also check 

any extension cables. Damaged safety guards 

and switches must be replaced before the 

machine is used again.

Lubrication

The machine requiers no additional lubrication.

Faults

Should a fault occur, e.g. after wear of a part, 

please contact the service address on the 

warranty card. In the back of this manual you find 

an exploded view showing the parts that can be 

ordered.

Environment

To prevent damage during transport, the appliance 

is delivered in a solid packaging which consists 

largely of reusable material. Therefore please 

make use of options for recycling the packaging.

Faulty and/or discarded electrical or 

electronic apparatus have to be collected 

at the appropriate recycling locations.

Warranty

The guarantee conditions can be found on the 

separately enclosed guarantee card.