9
EN
higher. Therefore lower the supply and the number
of revolutions and ensure a better discharge of
chips by regularly pulling back the drill. For drilling
with a greater diameter than 8 mm, pre-drilling
must take place, so that early wear of the drill -
main cutting edge can be avoided and so that the
drilling point is not too heavily loaded.
5. MAINTENANCE
Make sure that the machine is not live
when carrying out maintenance work on
the motor.
This machine has been designed to operate
over a long period of time with a minimum of
maintenance. Continuous satisfactory operation
depends upon proper machine care and regular
cleaning.
Cleaning
Keep the ventilation slots of the machine clean to
prevent overheating of the motor. Regularly clean
the machine housing with a soft cloth, preferably
after each use. Keep the ventilation slots free from
dust and dirt. If the dirt does not come off use a
soft cloth moistened with soapy water. Never use
solvents such as petrol, alcohol, ammonia water,
etc. These solvents may damage the plastic parts.
Please clean the tool immediately after use.
Lubrication
Every bearing in the drill press has been pre-
lubricated in the factory. Further lubrication is
unnecessary. From time to time, you should
grease the racks and pinions, the table lifting
mechanism, the spindle and the splines of the
hollow shaft. Open the drive belt guard and squirt
a little oil onto the spindle shaft. Do not allow any
oil to touch the drive belt!
Faults
Should a fault occur, e.g. after wear of a part,
please contact the service address on the
warranty card. In the back of this manual you find
an exploded view showing the parts that can be
ordered.
ENVIRONMENT
To prevent damage during transport, the
appliance is delivered in a solid packaging which
consists largely of reusable material. Therefore
please make use of options for recycling the
packaging.
Damaged and/or disposed of electrical
or electronic devices must be dropped
off at recycling stations intended for that
purpose.
Only for EC countries
Do not dispose of power tools into domestic
waste. According to the European Guideline
2012/19/EU for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable must
be collected separately and disposed of in an
environmentally friendly way.
WARRANTY
Read the warranty conditions on the separately
supplied warranty card.
The product and the user manual are subject
to change. Specifications can be changed
without further notice.
